User manual FABER LITHOS EG6 BK A45

[. . . ] The manufacturer will not be held liable for any damages resulting from The minimum safety distance between the cooker top and the extractor Hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). If the instructions for installation for the gas hob specify a greater distance, this must be respected. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. [. . . ] WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. Do not look directly at the light through optical devices (binoculars, magnifying glasses. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. Children should be supervised to ensure that they do not play with the appliance. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Clean and/or replace the Filters after the specified time period (Fire hazard). There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. "In case of replacement with halogen lamp use only self-shielded tungsten halogen lamps or self-shielded metal halide lamps. 1 Hood Canopy, complete with: Controls, Light, Fan unit, Filters Mark the following on the wall: · A vertical line up to the ceiling or surface above the hood, at the centre of the area in which The hood itself is to be fitted; · 1 as indicated, 1-2 mm from the ceiling or surface above the hood, Aligning its centre (grooves) with the vertical reference line. 1 as indicated, X mm under the first bracket (X = height of the Upper Chimney provided), aligning its centre (grooves) with the vertical reference line. As indicated above, mark a reference point 373 mm above the horizontal reference line, and 150 mm to the right of the vertical reference line. Repeat this operation on the opposite side, checking to ensure it is level. From inside the hood canopy, adjust the screws Vr to set the DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. [. . . ] Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. When refitting the filters, make sure that the handle is visible on the outside. These filters are not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently with heavy usage. [. . . ]