User manual FABER BIOS EG6 X F32

[. . . ] The manufacturer will not be held liable for any damages resulting from The minimum safety distance between the cooker top and the extractor Hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). If the instructions for installation of the gas hob specify a greater distance, this must be respected. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. [. . . ] This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. Children should be supervised to ensure that they do not play with the appliance. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Clean and/or replace the Filters after the specified time period (Fire hazard). There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. The person fitting the hood has to bear in mind that there must be a minimum distance of at least 8-10 Cm left between the top of the hood and the surface above it (ceiling or shelf). Draw the following on the Wall: · A Vertical line up to the ceiling or top surface, at the centre of the area in which the Hood is Mark a reference point, as indicated, 164 mm to the right of the vertical reference line and 59 mm to the left of the vertical reference line, checking to ensure it is level. 4) provided in the hood support fixing bores, leaving a Gap of 5-6 mm between the wall and the heads of the screws. Fix the directional grille 8 on the recirculation air Using 6 Screws 12d provided, join the Fan unit 3 to 12d Using 4 screws 12d provided, fasten the resulting assembly to the Hood Canopy 1 taking care to ensure 4 that the electrical wiring connected passes inside the Hood Canopy in the slot provided. Hook the Hood Support 2 to the 4 screws 12a protruding from The wall, checking the level. Lock the 2 screws 12a on the right that are visible and easy to Lock the 2 screws 12a on the left that can be reached through The holes on the left of the Hood Support, as shown in the figure. When the operation has been completed, insert the 2 Plugs 20 into the holes. Before carrying out any operation the Hood must be disconnected by removing the plug from the power socket or turning off the main switch. [. . . ] Dismantle the filter and wash the sponge-like part, making sure It is completely dry before you replace it. For replacement contact technical support ("To purchase contact technical support"). For din sikkerhed og for at sikre korrekt brug af apparatet anbefaler vi, at du læser denne brugsanvisning omhyggeligt inden installation og brug af apparatet. Sørg for, at børn ikke har mulighed for at lege med apparatet. [. . . ]