User manual ELECTROLUX EXP34U338CW

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Visit our website to: Get usage advice, brochures, trouble shooter, service information: www. Com Buy Accessories, Consumables and Original spare parts for your appliance: www. [. . . ] To cancel the setting, press the “timer” button again will show the remaing time and press the button again to quit the function. You can also cancel the setting by pressing the “on/off” button. Sleep mode Active this feature will give you a comfortable temperature and help save energy. Only when the unit is in Cool, Heat or auto mode, you can press the “sleep” button to make the unit run in Sleep mode. Note: Please refer to page 17 for the details about “Sleep” mode. Louver Swing Function Press the “swing” button to enable louver swing function, the louver on the top panel will swing up and down. °F/°C function Press the “ ” and “ ” button the same time for more than 3 seconds to switch between degree Fahrenheit and degrees Celsius. Filter reset This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The filter indicator will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “filter reset” button, then the “filter” indicator will go off. 2 Remote Control 1 Remote Control screen 2 Temp/Timer setting button 3 Mode button 4 Timer button 5 On/Off button 6 Speed button 7 Sleep button 8 Swing button Battery Installation and Important Instructions Remove the cover at the back of the remote control. Insert the provided batteries correctly (see the instructions inside the battery compartment). To replace the old batteries (which have been used up) with two new R03P “AAA” 1. If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in accordance with local legislation as they do harm to the environment. If the remote control is not used for a long time, remove the batteries from the remote control. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The remote control must be no more than 16 ft (5 meters) away from the unit (without obstacles between the remote control and the unit). How to Use the Remote Control TURNING THE UNIT ON ENGLISH 17 Plug in the unit, then press the “on/off” button (when turned on, the unit will operate as the last setting before shutdown. To switch the unit off, press “on/off” button again, then remove the plug. Always switch the unit off by pressing the “on/off” button and wait for few minutes before removing the plug. Cool mode Press the “mode” button until the left side of LCD screen displays “cool”. Press the “fan speed” button to choose the fan speed “auto”, “high”, “mid”, and “low”. [. . . ] Tryk eller hold på pil OP " " eller pil NED " " for at ændre timeren for udskudt start med trin på 0, 5 time op til 10 timer og derefter med trin på 1 time op til 24 timer. For at annullere indstillingen skal du trykke på knappen "Timer" igen for at se resterende tid eller tryk på knappen igen for at afslutte funktionen. Tryk eller hold på pil OP " " eller pil NED " " for at ændre timeren for stop med trin på 0, 5 time op til 10 timer og derefter med trin på 1 time op til 24 timer. For at annullere indstillingen skal du trykke på knappen "Timer" igen for at se resterende tid eller tryk på knappen igen for at afslutte funktionen. [. . . ]