User manual ELECTRO-VOICE BARONET DATASHEET

[. . . ] The mic is terminated in a TA4F connector wired for use with EV & Telex bodypack transmitters, and includes a two-stage foam windscreen, and a gig bag. Technical Specifications: Generating Element: Self-Biased condenser, back electret 2micron thick, gold sputtered diaphragm Frequency Response: 80 ­ 18kHz (see char t) Polar Pattern: (see char t) Cardioid Sensitivity, Open Circuit 1. 3mV / Pascal Voltage, 1kHz: Clipping Level: >148 dB SPL Equivalent Noise: 31 dB SPL Dynamic Range: > 117 dB Power Requirements: 5 VDC Output Impedance, 1 kHz: 1000 ohms Current Consumption: < 500 uA Dimensions Diameter (Mic) 0. 412" (10. 5 mm) Length (Mic) 0. 948" (24. 1 mm) less strain relief Length (Mounted) 6. 2" (158 mm) Cable: 0. 100" (2. 54 mm) Diameter x 5 ft (1. 5 m) long Connector Wiring: Pin Pin Pin Pin #1 #2 #3 #4 ­ ­ ­ ­ Ground, Shield Audio, White Bias Voltage, Red N/C Accessories Furnished: Two Stage Windscreen Gig Bag Color : Nonreflecting black Environmental Conditions: Relative Humidity 0-50%: -29° to 74° C (-20° to 165° F) Relative Humidity 0-95%: -29° to 57° C (-20° to 135° F) Net Weight: 1. 9 oz. (54 grams) Pre lim ina ry Frequency Response: +10 Polar Response: 0° 330° 30° 300° 60° 0 dB -10 270° 90° -20dB 20 50 100 500 1K 5K 10K 20K -15dB 240° -10dB -5dB @1kHz 210° 180° 150° 120° FREQUENCY IN HERTZ Application Notes: Cable Clips: The gooseneck on the RE920Tx includes a pair of soft vinyl clips to hold the microphone cable. [. . . ] (54 grams) Pre lim ina ry Frequency Response: +10 Polar Response: 0° 330° 30° 300° 60° 0 dB -10 270° 90° -20dB 20 50 100 500 1K 5K 10K 20K -15dB 240° -10dB -5dB @1kHz 210° 180° 150° 120° FREQUENCY IN HERTZ Application Notes: Cable Clips: The gooseneck on the RE920Tx includes a pair of soft vinyl clips to hold the microphone cable. These can be adjusted as needed to make sure the cable does not interfere with the use of your instrument. Using the Windscreen: The RE920Tx includes a windscreen that can be used anytime wind noise or breath pop is a problem. To install the windscreen, simply press it on the top of the microphone. The windscreen has an internal frame that includes a stop to help positioned the windscreen correctly. Pointing the mic towards the center of the bell will result in a brighter sounding tone. Woodwinds For a bright sound, clamp the microphone on the bell of the instrument and point it towards for the center of the bell. For a mellower sound, reverse the mic clamp so that mic points towards the instrument keys. Dimensions: 12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043 www. electrovoice. com © Telex Communications, Inc. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. For customer orders, contact Customer Service at: + 49 9421-706 0 Fax: + 49 9421-706 265 Other International locations. [. . . ] For a mellower sound, reverse the mic clamp so that mic points towards the instrument keys. Dimensions: 12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043 www. electrovoice. com © Telex Communications, Inc. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ]