User manual EINHELL BT-VC 1450 SA

[. . . ] Pull out the power plug in the following circumstances: Whenever the appliance is not in use, before opening the appliance and before all cleaning and maintenance work. Take care to ensure that the power cable does not get damaged by being run over, crushed, pulled or suchlike. Do not use the machine if the power cable is in a less than perfect condition. If the power cable has to be replaced, the replacement must comply with the design specifications of the manufacturer. [. . . ] Push the castors (12) firmly into the mounting until they engage with a clicking noise (Fig. 13/1) Place the handle (1) into the handle holders (16) and secure the handle with the supplied screws (34) as shown in figure 13. Anleitung_BT_VC_1450_SA_SPK7:_ 14. 10. 2008 7:58 Uhr Seite 8 GB Various attachments can be fitted to the combination nozzle depending on what you sort of work you wish to carry out: Wet vacuuming Use the attachment for wet vacuuming (Fig. Fit the appropriate attachment into the combination nozzle (14) from underneath and secure it to the combination nozzle (14) using the side lugs (fig. 3/23) The crevice nozzle (23) is designed for vacuuming solids and liquids in corners, edges and other areas that are difficult to access. The wet and dry vacuum cleaner is not suitable for the vacuuming of combustible liquids. 6. 4 Automatic mode Connect the power cable on your electric tool to the automatic socket-outlet (4) and connect the suction hose (9) to the extractor connector on your electric tool. You can use the supplied electric tool adaptor (22) to connect the suction hose (9) to the electric tool. To do so, fit it between the suction hose and the extractor port on the electric tool. Set the switch (7) on the wet and dry vacuum cleaner to position II, automatic mode. The moment you switch on the electric tool, the wet and dry vacuum cleaner switches on as well. When you switch off the electric tool, the wet and dry vacuum cleaner switches off as well after a pre-set delay. 6. 5 Blowing Connect the suction hose (9) to the blow connector (19) on the wet and dry vacuum cleaner. 6. 2/7) Switch position 0: Off Switch position I: Normal operation Switch position II: Automatic mode 6. 2. Dry vacuuming Use the pleated filter (24) for dry vacuuming (see point 5. 2). The tank bag (35) can also be fitted for removal particular heavy dirt (see point 5. 3). 6. 3 Wet vacuuming For wet-vacuuming, use the foam filter (25) (see point 5. 2). 1/11) To make the tank (10) easier to empty after wet vacuuming, it is fitted with a water drain screw (11). Open the water drain screw (11) by turning it anticlockwise and drain the liquid. When wet vacuuming, the floating safety switch (21) turns off the wet and dry vacuum cleaner automatically when the maximum level is reached. 7. Always pull out the mains power plug before starting any cleaning work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. b We recommend that you clean the appliance immediately after you use it. b 7. 2 Cleaning the appliance head (5) Clean the appliance regularly with a damp cloth and some soft soap. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]