User manual EINHELL BT-TS 800

[. . . ] Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, give them these operating instructions as well. We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. To use the machine properly you must also observe the safety regulations, the assembly instructions and the operating instructions to be found in this manual. [. . . ] During the OFF period the motor will cool again to its starting temperature. Anleitung BT-TS 800_SPK1:_ 25. 09. 2007 9:09 Uhr Seite 12 GB time after changing the saw blade. Insert the screw (15) through the hole in the saw blade guard (2) and in the splitter (5) and secure it with the nut. You can now adjust the blade (4) to the required angle (see scale (13)) by sliding the two star-grip screws (14). Sawing operations After each new adjustment it is advisable to carry out a trial cut in order to check the set dimensions. After switching on the saw, wait for the blade to reach its maximum speed of rotation before commencing with the cut. Secure long workpieces against falling off at the end of the cut (e. g. 11) Adjust the parallel stop (7) to the width of workpiece you require. (A push stick is supplied with the saw!) Always push the workpiece through to the end of the splitter (5). 9. 2 Cutting extremely narrow workpieces (width less than 30 mm) Adjust the parallel stop (7) to the width of workpiece you require. Use the push block (d) to press the workpiece against the stop rail (25) and push the workpiece with the push stick (3) through to the end of the splitter (5). 7/8) The parallel stop (7) supplied with the benchtype circular saw has two different guide faces. To change the height of the stop, slacken the two knurled screws (12) and pull the stop rail off the carrier rail. Turn the stop rail (25) 180° to the left or the right, depending on the required height of the stop, and plug in back on the carrier rail (26). 8) The parallel stop (7) has to be used when making longitudinal cuts in wooden workpieces. Slide the parallel stop (7) to the right or left side of the saw table (1). The parallel stop (7) can be set to the required dimension with the help of the scale (b) engraved on the saw table (1). Tighten the two thumb screws (12) in order to fix the parallel stop (7). 10. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 10. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. 12 Anleitung BT-TS 800_SPK1:_ 25. 09. 2007 9:09 Uhr Seite 13 GB Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 10. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]