User manual EINHELL BT-RH 600

[. . . ] Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. LpA sound pressure level KpA uncertainty LWA sound power level KWA uncertainty 88. The hammer drill is not designed for outdoors use as specified I Article 3 of Directive 2000/14/EC_2005/88/EC. [. . . ] Benefits: The drill bit is easier to control when starting the hole and will not slide away. 6/Item 11) The speed setting ring (11) enables you to define the maximum speed. The ON/OFF switch (4) can only be pressed to the defined maximum speed setting. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (9): Direction Clockwise (forwards and drill) Counter-clockwise (reverse) Switch position A B immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. The carbon brushes should not be rep laced by anyone but a qualified electrician. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. T The product meets the requirements of EN 61000-3-11 and is subject to special connection conditions. This means that use of the product at any freely selectable connection point is not allowed. Given unfavorable conditions in the power supply the product can cause the voltage to fluctuate temporarily. The product is intended solely for use at connection points that a) do not exceed a maximum permitted supply impedance "Zsys= 0, 25 + j0, 25 ø", or b) have a continuous current-carrying capacity of the mains of at least 100 A per phase. As the user, you are required to ensure, in consultation with your electric power company if necessary, that the connection point at which you wish to operate the product meets one of the two requirements, a) or b), named above. K t p erklärt folgende Konformität gemäß EU-Richtlinie und Normen für Artikel declares conformity with the EU Directive and standards marked below for the article déclare la conformité suivante selon la directive CE et les normes concernant larticle verklaart de volgende conformiteit in overeenstemming met de EU-richtlijn en normen voor het artikel declara la siguiente conformidad a tenor de la directiva y normas de la UE para el artículo declara a seguinte conformidade de acordo com a directiva CE e normas para o artigo förklarar följande överensstämmelse enl. T For EU countries only Never place any electric tools in your household refuse. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]