User manual EINHELL BT-PG 850

[. . . ] Altitude above sea level 1000 m, relative humidity: 90 % (non-condensing) The generator is driven by a combustion engine, which produces heat in the area of the exhaust (on the opposite side of the sockets) and the exhaust outlet. You should therefore keep clear of these surfaces because of risk of skin burns. The values quoted in the technical data for sound power level (LWA) and sound pressure level (LWM) are emission values and not necessarily reliable workplace values. As there is a correlation between emission and immission levels, the values are not a reliable basis for deciding on any additional precautions which may be needed. [. . . ] Operating mode S2 (temporary operation) The machine may be temporarily operated with the quoted power output. Afterwards the machine must be stopped for a while to prevent it from overheating. Before putting the machine into operation The generator is to be operated only with equipment whose voltage specifications conform with the generator's output voltage. 3a) and fit into the recess on the bottom of the tank cover (Figure 3b). Use the set of screws (9) to fasten the carry handle (2) onto the tank (Fig. 4 Connecting to earth The housing is allowed to be connected to earth in order to discharge static electricity. To do this, connect one end of a cable to the earth connection on the generator (Fig. 4) and the other end to an external earth (for example an earthing rod). 1 Starting the engine Open the petrol cock (8) by turning it down Move the ON/OFF switch (5) to position "ON" with the key. When starting with the reserve starter, the motor may recoil suddenly as it starts up, resulting in hand injuries. 2 Connecting consumers to the generator Connect the appliance you want to use to the 230 V~ socket. Important: This socket may be loaded continuously (S1) with 650W and temporarily (S2) for a maximum of 15 minutes with 800W. Do not connect the generator to the household network as this may result in damage to the generator itself or to other electrical appliances in your home. ) may have a higher level of power consumption when used in difficult conditions. 3 Switching off the engine Before you switch off the generator, allow it to run briefly with no consumers so that it can "cool down" Move the ON/OFF switch (5) to position "OFF" with the key. Close the petrol cock Important: The generator is equipped with an overload cut-out. If this happens, reduce the electric power you are taking from the generator or remove any defective connected appliances. Before using the appliance for the first time the tank must be filled with a petrol mixture in a mixing ratio of 1:50. Check the fuel level and top it up if necessary Make sure that the generator has sufficient ventilation Make sure that the ignition cable is secured to the spark plug Inspect the immediate vicinity of the generator Disconnect any electrical equipment which may already be connected to the generator Mixture Regular unleaded Petrol 1l 1:50 2l 3l 4l 2- stroke - Öl 20 ml 40 ml 60 ml 80 ml Switch off the motor and pull the spark plug boot from the spark plug before doing any cleaning and maintenance work on the equipment. Important: Switch off the machine immediately and contact your service station: In the event of unusual vibrations or noise If the engine appears to be overloaded or misfires 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]