User manual EINHELL BT-JS 800 E

[. . . ] Proper use The jigsaw is designed for sawing wood, iron, nonferrous metals and plastics using the appropriate saw blades. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. 1. [. . . ] General rules for cutting speeds for metal cutting work must be complied with here as well. You can generally use a higher speed with fine saw blades whilst coarser saw blades require lower speeds. Position 1-2 = low stroke speed (for steel) Position 3-4 = medium stroke speed (for steel, soft metal, plastic) Position 5-6 = high stroke speed (for softwood, hardwood, soft metal, plastic) 6. 4 Setting the pendulum action (Fig. 3/Item 8) The strength of the pendulum action of the saw blade (12) can be adjusted using the selector switch for pendulum action (8). You can adjust the cutting speed, the cutting performance and the finish to the workpiece you wish to saw. Set the selector switch for pendulum action (8) to one of the following positions: Position 0: No pendulum action Material: Rubber, ceramic, aluminium, steel Please note: For fine and clean cuts, thin materials (e. g. Position 1: Small pendulum action Material: Plastic, wood, aluminium Please note: For hard materials Position 2: Medium pendulum action Material: Wood Position 3: Large pendulum action Material: Wood Please note: For soft materials and sawing along the grain The best combination of speed and pendulum action depends on the material you wish to saw. We recommend you to make a trial cut on a waste piece in order to check the ideal settings. 9/Item 16) The LED lamp (16) can be used in poor lighting conditions to additionally illuminate the cutting position. When cutting metal, apply a suitable coolant along the line you wish to cut. Insert the saw blade into this hole and start to saw out the required section. 6. 8 Making parallel cuts Mount the parallel stop and adjust as required (see section 5. 3). 6. 9 Making miter cuts Set the angle on the soleplate (see section 5. 4). Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 13 Anleitung BT-JS 800 E_SPK1:_ 15. 09. 2008 13:31 Uhr Seite 14 GB 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. The carbon brushes should not be rep laced by anyone but a qualified electrician. 8. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 8. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]