User manual EINHELL BT-CS 1200

[. . . ] The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. 1. Safety regulations The corresponding safety information can be found in the enclosed booklet. [. . . ] 6. 2 Using the circular saw Adjust the cutting depth, cutting angle and parallel stop (see section 5. 1, 5. 2 and 5. 4) Ensure that the ON/OFF switch (2) is not depressed. 10) To switch on: Press the locking button (3) and the ON/OFF switch (2) at the same time Allow the saw blade to accelerate until it reaches full speed. To switch off: Release the locking button and ON/OFF switch If you release the handle the equipment will shut down automatically which means that it cannot operate accidentally. Ensure that you do not cover or block the ventilation openings whilst working with the tool. 13 Do not slow down the saw blade after you switch it off by pressing it sideways. Do not put down the machine until the saw blade has reached a complete standstill. Carry out a trial cut in a piece of waste wood 6. 4 Changing the saw blade (Fig. Always pull out the power plug before doing any work on the circular saw!Only use saw blades of the same type as the saw blade supplied with this circular saw. Push back and secure the moving swing guard hood (19) using the lever for the swing guard hood (15). Use the saw blade wrench (13) to apply counterpressure to the flange (18). Remove the flange (18) and the saw blade (12) in a downwards direction. Pay attention to the running direction (see arrow on the guard hood and saw blade). Before you press the On/Off switch, make sure that the saw blade is correctly fitted and that moving parts run smoothly and the clamping screws are tightened securely. 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Anleitung_BT_CS_1200_SPK1:_ 01. 02. 2008 7:23 Uhr Seite 14 GB 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. The carbon brushes should not be rep laced by anyone but a qualified electrician. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]