User manual EINHELL BG-PW 48

[. . . ] Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. [. . . ] 2 Maintenance In this connection, please also read the attached service information 7. 1 Changing the oil The engine oil is best changed when the engine is at working temperature Use only engine oil (10W40). Place the machine on a slightly inclined surface so that the oil drain plug is at the lower end (Figure 5a / Item A). Remove the oil drain plug and drain the warm engine oil into a suitable container. After all the oil has drained, screw in the oil drain plug and place the machine on a flat surface. Insert fresh engine oil up to the top mark on the oil dipstick (Figure 5b / Item H). While the machine is working, the oil level must be between the two marks "L" and "H" (Figure 5b). Remove the screw from the air filter cover (Figure 6a) Remove the air filter cover. remove the screw from the air filter element (Figure 6b) Remove the air filter element (Figure 6c). Clean the air filter by tapping it, blowing it out with compressed air or by washing it with soap suds. Remove the spark plug boot by twisting it (Figure 7) Remove the spark plug using a spark plug wrench Clean the spark plug with a copper wire brush or fit a new one. Disconnect the spark plug boot before doing any cleaning and maintenance work!1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. 3 Storage Rinse the pump thoroughly with water before lengthy periods of inactivity or winter storage. Close the petrol cock and allow the engine to run until it stops to empty the carburetor. 4 Ordering replacement parts Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. [. . . ] The guarantee is valid for a period of 2 years starting from the purchase date of the device. Guarantee claims should be submitted before the end of the guarantee period within two weeks of the defect being noticed. no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. [. . . ]