User manual EINHELL BG-PT 2643

[. . . ] Vor Inbetriebnahme Bedienungsanleitung und Sicherheitshinweise lesen und beachten Read and follow the operating instructions and safety information before using for the first time. Safety Regulations Layout and items supplied Intended use Technical data Before starting the equipment Operation Cleaning, maintenance and ordering of spare parts Disposal and recycling Troubleshooting When using the equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. [. . . ] To extend the cutting line run the motor at full speed and tap ("BUMP") the cutting head on the ground. The blade on the safety shield will cut the line to the appropriate length (Fig. DIFFERENT CUTTING METHODS If the machine is correctly assembled with the safety hood and cutting head it will cut weeds and long grass in places with difficult access, for example along fences, walls and foundations and also around trees. It can also be used for mowing work to remove vegetation to allow the better preparation of a garden or to clear a certain area down to the soil. PLEASE NOTE: Even if it is used carefully, cutting around foundations, stone or concrete walls, etc. tRIMMING / MOWING Swing the trimmer from side to side in a scything motion. Guide and hold the cutting head at the required height to ensure that you cut evenly (Fig. LOWER TRIMMING Hold the trimmer right in front of you at a slight angle so that the underside of the cutter head is above the ground and the line strikes the correct target. CUTTING ALONG FENCES / FOUNDATIONS When cutting approach wire mesh fences, lath fences, natural stone walls and foundations slowly so that you can cut close to them without striking the obstacle with the line. If, for example, the line strikes stones, stone walls or foundations, it will wear or fray. TRIMMING AROUND TREES When trimming around tree trunks, approach slowly so that the line does not strike the bark. Approach grass or weeds with the tip of the line and tilt the cutting head forwards slightly. When doing such work keep a distance of 30 meters between yourself and other people or animals. MOWING For mowing you want to cut all the vegetation down to the ground. Remember the increased risk of injury to the user, watchers and animals and the danger of damaging other items due to objects (for example stones) being thrown out (Fig. The trimmer is a powerful tool and can throw small stones and other objects a distance of 15 meters or more, causing injuries and damage to cars, houses and windows. Maintenance Always switch off the machine and pull out the spark boot plug before carrying out any maintenance work. The following steps only have to be carried out if only the line and not the entire spindle requires replacing: Remove the remaining cutting line from the spool. Hold the two halves of a new cutting line together in the middle and place the loop in one of the slots on the spool divider (Fig. Fit the springs on the inside of the spool and thread each of the ends of the line through one of the eyelets in the spool holder (Fig. Make sure that the spring slides over the spindle and does not get stuck. Press the spool into the spool holder with your hand and use your other hand to fasten the retainer screw tightly (Fig. [. . . ] Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. [. . . ]