User manual DREMEL 800

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use an earth leakage circuit breaker. Use of an earth leakage circuit breaker reduces the risk of electric shock. Have your power tool serviced by a qualified repair person using only identical replacement parts. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. Remove any adjusting key or wrench before switching the power tool on. seeFigure4: A Large Knob B Depth of Cut C Table D Depth Adjustment Screw E ToolHolderAssembly Adjustment markings on the side of the tool holder facing outward are marked in inches and millimeters. Forbestcontrolandqualityofcut, feedthework into the bit in the direction that the bit will tend to pull the work to the fence. SeeFigure6 Feeddirectionisextremelyimportantwhenusingapilotbitfreehand on the edge of a workpiece as well as when using the fence with all bits. SeeFigure7a:Feed Direction without Fence SeeFigure7b:Feed Direction with Fence A FeedDirectionArrow Tips Table: 1. Special cases when the fence must be removed from the table, adjust the centre cylinder of the guard down to provide protection from revolving cutter. Theworkpiece should be kept between the cutter and the operator, and fed from right to left. Feedtheworkpiecepastthecutterwithoutstoppingandwith a consistent speed, A change in feed or a dwell will cause an irregular cut. TheShaper/Routertableisdesignedtomakeiteasytoexpandthe size of the working surface. Cut a rectangular hole in the plywood to fit over the table and secure using (8) #10 wood screws, 12 mm in length. Support the table at both ends by securing 40 mm high lumber supports to the plywood base. Unplug the rotary tool before making any fence adjustments or bit changes. [. . . ] Most fence cutting is done with the support wedge adjusted to the right where it is in line with the fence. ThisDREMELproductisguaranteedinaccordancewithstatutory/ country-specific regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. In case of a complaint, send the tool undismantled together with proof of purchase to your dealer. Center cylinder of the guard can be adjusted up when making cuts using the fence. [. . . ]