User manual DREMEL 780

[. . . ] The unit must not be damp and must also not be operated in damp surroundings. Connect units that are used outdoors by means of a fault current protection switch (FI) with a maximum triggering current of 30 mA. This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Dremel is able to ensure flawless functioning of the unit only if the original accessories intended for it are used. do not work materials containing asbestos (asbestos is considered carcinogenic). Take protective measures when during work dust can develop that is harmful to one's health, combustible or explosive (some dusts are considered carcinogenic); wear a dust mask and work with dust/ chip extraction when connectable. Do not change nozzles while glue gun is in "on" position, plugged in, or warm to the touch. Before changing nozzles, make sure glue gun is cool to the touch, unplugged, and the switch is in the "off" position. The unit, accessories and packaging should be sorted for environment-friendly recycling. This prevents the glue from dripping when the glue gun is at operating temperature. NOTES: During heating-up the glue gun may release a few drops of glue. CHANGING GLUE STICKS Do not attempt to remove the unused portion of the glue stick from your glue gun. If you need to switch glue stick formulas, empty the melting chamber by squeezing the trigger and insert new formula. Push stand (4) into "down" position when temporarily not in use (models 910, 920 and 930). â· Push the stand release button (8) to release the stand (model 940). When re-using or storing, push stand back into "up" position. For more information on the Dremel assortment, support and hotline, go to www. [. . . ] â· Push the stand release button (8) to release the stand (model 940). When re-using or storing, push stand back into "up" position. For more information on the Dremel assortment, support and hotline, go to www. [. . . ]