User manual DREMEL 750

[. . . ] This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. [. . . ] There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Before plugging in the tool, be certain that the outlet voltage you are using matches the voltage number marked on the back label (name plate label) that is located on the engraver. To use the engraver, turn the engraver "ON" by moving the on/off switch located at the end of the tool (figure 2). hold the engraver at a slight angle as you would normally hold a pencil. Use a light touch guiding the point over the work somewhat slower than you would normally write. A good "rule of thumb" is to select the lowest setting which will produce a deep enough engraving mark to meet your requirements. To familiarize yourself, experiment with different settings on scrap materials. NOTE: The "lowest" position of the adjusting knob will be with the knob pointing to the number "1" on the housing. With extended use, the positive detent indicator associated with the depth control knob will begin to wear down and be less noticeable. This is to be expected and does not indicate malfunction of the engraver. [. . . ] With extended use, the positive detent indicator associated with the depth control knob will begin to wear down and be less noticeable. This is to be expected and does not indicate malfunction of the engraver. Under most conditions it will perform very satisfactorily on glass, steel, ceramics and other hardmaterials. [. . . ]