User manual DREMEL 1453 CHAIN SAW SHARPENING ATTACHMENT

[. . . ] When all of the teeth on the top of the bar have been sharpened, advance the chain using a glove or a rag by pulling the chain toward the end of the bar. Repeat until all the teeth on the far side of the chain have been sharpened. Turn the saw around so that you are looking at the side of the chain bar with the motor to your left. [. . . ] For more information on the Dremel assortment, support and hotline, go to www. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. Remove any adjusting key or wrench before switching the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not switch it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. [. . . ] Cutter teeth on the far side of the chain are sharpened, from inside to outside as shown in Figure 6. Lay the guide (B) flat on the tooth with the 30º index line (A) parallel with the chain. Two or three light strokes are usually enough unless the cutters have been damaged. [. . . ]