User manual DRAKE DIGITAL PS8 DATASHEET

[. . . ] x 8 Fuse (Internal, AC input): 2A, 250 V SLO-BLO 5 x 20 mm (Power supply assembly employs short circuit and over-voltage protection). ACCESSORY SUPPLIED AC Power Cord: -------------------------------- 6 Ft. , IEC, USA POWER SUPPLY PS8 PS8 Rear Panel Connections Both the AC input receptacle and DC output connector are located on the rear panel of the power supply module. AC Input - The power supply accepts standard 100 to 240 VAC, 50/60 Hz inputs (and -10%/+10% of that voltage range). [. . . ] Water and Moisture--Do not use this product near water--for example, near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool--and the like. Accessories--Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the appliance. Ventilation--This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. To ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. Grounding or Polarization--This product is equipped with a 3- wire line cord receptacle. Mise à la terre ou Polarisation--Cet appareil est équipé avec un cordon d'alimentation à trois fils. Power Sources--This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your appliance dealer or local power company. Power-cord Protection--Power-supply cords should be routed so they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. 13. Lightning--For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet. Power Lines--An outside antenna system should not be located in the vicinity of overhead power lines, other electric light or power circuits, where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them may be fatal. Overloading--Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock. Object and Liquid Entry--Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. [. . . ] Secure antenna lead-in and ground wires to house with stand-off insulators spaced from 4 feet (1. 22m) to 6 feet (1. 83m) apart. Mount antenna discharge unit as close as possible to where lead-in enters house. A driven rod may be used as the grounding electrode where other types of electrode systems do not exist. [. . . ]