User manual DOLMAR TM-92.14 H

[. . . ] We hope that you will get complete satisfaction from using your new machine and that it will fully meet all your expectations. This manual has been compiled in order that you may get to know your machine and to be able to use it safely and efficiently. Don't forget that it forms an integral part of the machine, so keep it handy so that it can be consulted at any time, and pass it on to the purchaser if you resell the machine. This new lawn tractor of yours has been designed and made in line with current regulations, and is safe and reliable if used for cutting and collecting grass in full accordance with the instructions given in this manual (proper usage). [. . . ] It has to be used (as indicated by the highway code) in private areas closed to traffic. NOTE When moving the machine, the blades must be disengaged and the cutting deck put at its highest position (position «7»). Put the accelerator control between the «SLOW» and «FAST» positions, and the gear change lever in the 1st speed position ( 4. Slowly release the pedal which will turn from «brake» to «clutch», thus operating the rear wheels ( 4. The pedal has to be released gradually as a sudden engagement may cause tipping up and loss of control of the vehicle. Gradually reach the desired operating speed using the accelerator and gear lever. To change the gear speed the clutch must be used pushing the pedal half way down ( 4. When moving the machine from one area to another, put the accelerator lever in a midway position between «SLOW» and «FAST». 32) in direction »F» and reach the required speed by progressively increasing pressure on the pedal and moving the accelerator appropriately. 32) to prevent sudden engagement from causing tipping up and loss of control of the vehicle, particularly on slopes. NOTE The machine already slows down considerably by just releasing the drive pedal. Push down the pedal until the machine stops and then go into reverse by moving the lever sideways and putting it into position «R» ( 4. Gradually release the pedal to engage the clutch and then begin moving in reverse. When the machine is stopped, start the reverse movement by pressing the drive pedal in the «R» direction ( 4. To start cutting: ­ put the accelerator into the «FAST» position; ­ bring the cutting deck to the highest position; ­ engage the blades ( 4. ­ start moving forwards onto the grass area very gradually and with particular caution, as already described; ­ adjust the forward speed and the cutting height ( 4. 8) according to the lawn condition (height, density and dampness of the grass). On flat ground, these general conditions can be followed: High and dense grass - wet lawn Average condition grass Low grass - dry lawn 2 km/h 3, 5 . The speed is controlled in a gradual and progressive way by the pressure on the drive pedal. When cutting on sloping ground, the forward speed must be reduced to ensure safe conditions ( 1. In any case, the speed should always be lowered if you note a reduction in engine speed, since a forward speed that is too fast compared to the amount of grass being cut will never mow the grass well. Disengage the blades and put the cutting deck in the highest position whenever you need to get past an obstacle. [. . . ] 2 REPLACING AND REPAIRING TYRES The tyres are of the «Tubeless» type and therefore all puncture repairs will have to be carried out by a tyre-repair expert in accordance with the methods for this kind of tyre. 3 REPLACING BULBS ( if fitted) The bulbs (18W) have a bayonet fitting and are installed in the bulb holder which can be taken out by turning it anti-clockwise, using pliers. 4 REPLACING A FUSE The machine is fitted with fuses (1) with different capacities and functions. When it blows, the machine stops and the dashboard light switches off. [. . . ]