User manual DOLMAR PS-420 S SPARE PARTS LIST

[. . . ] Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Symbols END008-1 The following show the symbols used for the equipment. Only for EU countries Do not dispose of electric equipment or battery pack together with household waste material!In observance of European Directive 2002/96/EC on waste electric and electronic equipment, 2006/66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Instructions may result in electric shock, fire and/or serious injury. [. . . ] Except in case of emergency, never drop or cast the equipment to the ground or this may severely damage the equipment. Remember to lift the entire equipment from the ground when moving the equipment. Always remove the battery cartridge from the equipment: - whenever leaving the equipment unattended; - before clearing a blockage; - before checking, cleaning or working on the equipment; - after striking a foreign object; - whenever the equipment starts vibrating abnormally. Operation within a blade segment between 12 and 2 o'clock presents positive hazards, especially when using metal cutting tools. Cutting operations within a blade segment between 11 and 12 o'clock, and between 2 and 5 o'clock, must only be performed by trained and experienced operators, and then only at their own risk. Easy cutting with almost no kickback is possible within a blade segment between 9 and 11 o'clock. Thickness), perform the cutting work by swinging the equipment evenly in half-circles from right to left (similar to using a scythe). The condition of the equipment, in particular of the cutting tool of the protective devices and also of the shoulder harness must be checked before commencing work. Particular attention is to be paid to the cutting blades which must be correctly sharpened. Turn off the motor and remove the battery cartridge before carrying out maintenance, replacing/ sharpening cutting tools or cleaning the equipment or cutting tool. Check loose fasteners and damaged parts such as cracks in the cutting attachment. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the equipment, causing injury to you or someone around you. Always be sure that the equipment is switched off and the battery cartridge is removed before removing the weeds or similar entangled in the cutting tool that 11 Cannot be removed in spite of using the reversing switch. cAUTION: · Always check the direction of rotation before operation. Use the reversing switch only after the equipment comes to a complete stop. Changing the direction of rotation before the equipment stops may damage it. Depress the reversing switch lever from the A side for counterclockwise (normal) rotation or from the B side for clockwise (reverse) rotation. In the reversing mode, the equipment automatically stops in a short time after turned on. To change the speed range, turn the speed change switch lever so that it points toward "1" for low speed or "2" for high speed. The battery cartridge and machine are equipped with protection systems, which automatically reduces or cuts off the output power for their long service life. under overloaded situation , the protector drops the revolution to protect the motor. [. . . ] Do not allow the machine to be deflected toward you or anyone in the work vicinity. Always mount not only guard but also guard extension when using nylon cutting head. If the nylon cutting head hits against a stone during operation, stop the motor and check the nylon cutting head immediately. Turn the machine upside down so that you can replace the nylon cutting head easily. [. . . ]