User manual DOLMAR MS-2501

[. . . ] You will note the following symbols when reading the instructions manual. Read instruction manual and follow the warnings and safety precautions!­ To ensure correct operation, user has to read this instruction manual to make himself familiar with the handling of the Petrol Brushcutter. Users insufficiently informed will risk danger to themselves as well as others due to improper handling. [. . . ] ­ Fix a barrier to the left side of the machine together with the handle for operator protection. ­ Do not adjust position of the loop handle too close to the control grip. To meet the applicable safety provisions, only the tool/ protector combinations as indicated in the table must be used. ­ The cutter blade must be well polished, free of cracks or breakage. If the cutter blade hits against a stone during operation, stop the engine and check the blade immediately. ⭠Polish or replace the cutter blade every three hours of operation. ­ If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately. CAUTION: The appropriate protector must always be installed, for your own safety and in order to comply with accidentprevention regulations. Operation of the equipment without the guard being in place is not permitted. The outside diameter of the cutter blade must be 230 mm (9 - 1/16"). Never use any blades surpassing 230 mm (9 - 1/16") in outside diameter. The tank cap is consumable, and therefore should be renewed every two to three years. ­ Adjust the strap length so that the cutter blade will be kept parallel with the ground. ­ In an emergency, push the notches (1) at both sides, and you can detach the machine from you. Do not allow the machine to be deflected toward you or anyone in the work vicinity. WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH. ­ In an emergency, push the notches (2) at both sides, and you can detach the machine from you. Do not allow the machine to be deflected toward you or anyone in the work vicinity. WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool does not come into contact with the ground or any other objects. OPERATION STOP High speed Lock-off lever STOP Throttle lever Low speed High speed (1) OPERATION Lock-off lever 3) Primer pump Continue to push the primer pump until fuel enters into the primer pump. 4) Recoil starter Pull the start knob gently until it is hard to pull (compression point). [. . . ] Filters found to have hardened, been polluted or clogged up are to be replaced. ­ Insufficient fuel supply can result in the admissible maximum speed being exceeded. It is therefore important to replace the fuel filter at least quarterly to ensure satisfactory fuel supply to the carburetor. If any leakage is detected during inspection, replace the oil pipe immediately. [. . . ]