User manual DOLMAR HT-6500 PARTS LIST 06-02

[. . . ] If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Do not remove cut material or hold material to be cut when blades are moving. A moment of inattention while operating the hedge trimmer may result in serious personal injury. When transporting or storing the hedge trimmer always fit the cutting device cover. Proper handling of the hedge trimmer will reduce possible personal injury from the cutter blades. During operation the cable may be hidden in shrubs and can be accidentally cut by the blade. Do not use the hedge trimmer in the rain or in wet or very damp conditions. First-time users should have an experienced hedge trimmer user show them how to use the trimmer. The hedge trimmer must not be used by children or young persons under 18 years of age. Young persons over 16 years of age may be exempted from this restriction if they are undergoing training under the supervision of an expert. Never use the trimmer when under the influence of alcohol, drugs or medication. Using the waist cord hook helps to minimizing a risk of cutting off the extension cord unexpectedly caused by the loose extension cord. Always be sure that the tool is switched off and unplugged before installing or removing chip receiver. nOTE: · When replacing the chip receiver, always wear gloves so that hands and face does not directly contact the blade. Always be sure to remove the blade cover before installing the chip receiver. 17) Press the chip receiver on the shear blades so that its slits overlap with the nuts on the shear blades. At this time, make sure that the chip receiver does not contact branch catcher at the top of the shear blades. 18) At this time, the chip receiver needs to be installed so that its hooks fit into grooves in the shear blade unit. 19) To remove the chip receiver, press its lever on both sides so that the hooks are unlocked. The blade cover (standard equipment) cannot be installed on the tool with the chip receiver being installed. Before carrying or storing, uninstall the chip receiver and then install the blade cover to avoid blade exposure. Never try to uninstall the chip receiver by an excessive force with its hooks locked in the blade unit grooves. [. . . ] 13) Attaching the chip receiver (accessory) on the tool when trimming the hedge straight can avoid cut off leaves' being thrown away. 14) To cut a hedge side evenly, it helps to cut from the bottom upwards. 15) Trim boxwood or rhododendron from the base toward the top for a nice appearance and good job. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. [. . . ]