User manual DOLMAR HT-2249 D

[. . . ] WARNING: To reduce the RISK of injury, user must read and understand the instruction manual before using the Hedge Trimmer. manufacturer reserves the right to change specifications without notice. We are pleased to be able to offer you the DOLMAR Hedge Trimmer which is the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models HT-2249 D combines the advantages of state-of-the-art technology with ergonomic design, they are light weight, handy, compact and represent professional equipment for a great variety of applications. [. . . ] change your clothing instantly if fuel has been spilt on it (to prevent clothing catching fire). Inspect the fuel cap at regular intervals making sure that it can be securely fastened and does not leak. Change location to start the engine (at least 3 meters away from the place of refuelling. Thoroughly clean the area around the tank cap to prevent dirt from getting into the fuel tank. If not held down properly, the engine could pull you off balance or swing the cutting blade into an obstruction or your body. Slowly pull the starter grip until resistance is felt and continue with smart pull until initial ignition are heard. Depress the choke lever (3) to the position ( again until the engine starts. As soon as the engine starts, immidiately tap and release the throttle, thus releasing the half-throttle rock so that the engine can run in idle. Run the engine for approximately one minute at a modeate speed before aplying full speed. The starter handle is pulled repeatedly when the choke lever remains at " " position, the engine will not start easily due to excessive fuel intake. â· In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Hot starting: (Restarting immediately after the engine has stopped) When restarting a hot engine, first try the above procedure: 1, 5, 7, 8. Note: Do not pull the starter rope to its full extent and do not allow the starter grip to be retracted without control, ensure that it is retracted slowly. Push the I-O switch (1) to "O" position, the engine rotation will become low and the engine will stop. Never touch the cutting device when starting the engine and during operation. operate the Hedge Trimmer in such a manner as to avoid inhalation of the exhaust gases. All protective installations and guards supplied with the machine must be used during operation. Never operate the engine with a faulty exhaust muffler or if it is missing. During the winter season beware of slippery or wet areas, ice and snow. Keep both feet on the Never climb up the trees with the Hedge Trimmer to perform cutting operation. Before commencing cutting, the cutting blades must have reached full working speed. Always hold the Hedge Trimmer firmly with both hands on the handles only. [. . . ] Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. [. . . ]