User manual DOLMAR ES2141KTLC

[. . . ] 5 mm2 • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Weight according to EPTA-Procedure 01/2003 Symbol END218-7 The following show the symbols used for the equipment. Read instruction manual and follow the warnings and safety instructions. Only for EU countries Do not dispose of electric equipment together with household waste material! [. . . ] Removing or installing sprocket cover To remove the sprocket cover, perform the following steps: (For nut models) (Fig. Engaging extension cord CAUTION: • Make sure that the extension cord is unplugged to the mains outlet. 19) When engaging the extension cord, secure it to the chain saw’s cord with the cord hook. Attach the cord hook about 100 - 200 mm from the extension cord connector. Removing or installing saw chain CAUTION: • Always wear gloves when installing or removing the saw chain. (For nut models) Turn the chain adjusting screw counterclockwise to release the saw chain tension. (For lever models) Turn the adjusting dial to “-” direction to loosen the saw chain tension. Fit in one end of the saw chain on the top of the guide bar and the other end of it around the sprocket. 13) OPERATION CAUTION: • Hold the tool firmly with right hand on the rear handle and left hand on the front handle when performing the tool. 20) CAUTION: • Always be sure that the tool is switched off and unplugged before checking function on the switch trigger. € Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. CHECKS Before starting work, carry out the following checks: Checking the chain tension WARNING: • Always withdraw the mains plug before checking the chain tension, and wear safety gloves. 18) Make sure the saw chain fits snugly against the lower side of the bar (see circle). Check the chain tension frequently, as new chains are subject to elongation. Excessively high tension of saw chain may cause breakage of saw chain, wear of the guide bar and breakage of the adjusting dial. A chain which is too loose can jump off the bar, and therefore presents an accident risk. If the chain is too loose: Refer to the section titled “Adjusting saw chain tension” and adjust the saw chain tension again. Checking the chain oiler Before starting work, check the oil level in the tank, and the oil delivery. With the saw running, hold the saw chain approximately 15 cm above a tree trunk or the ground. If lubrication is adequate, the oil spray will produce a light oil trace. Observe the wind direction, and do not expose yourself to the oil spray unnecessarily. Clean the oil feed groove and the oil feed hole in the bar (refer to “MAINTENANCE”). [. . . ] Beyond two years after manufacture, biological oils begin to acquire an adhesive quality, and Malfunction status Possible cause No power supply. TROUBLE SHOOTING Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. Stop using the tool immediately, and ask your local authorized service center. [. . . ]