User manual DOLMAR ES-36 A PARTS LIST 2003-11

[. . . ] This will assist you to safety obtain the best possible Operation method . It is very important to understand the following symbols when reading this instructions manual. To ensure correct and safe operation, the user must read, understand and follow this instruction manual to assure familiarity with the handling of the blower (1). Users insufficiently informed will risk danger to themselves as well as others due to improper handling. [. . . ] (6) (5) Hold the main handle with a left hand to prevent the engine from moving, settle down to take the stable position. (6) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it out with force. Open the choke lever progressively while checking the engine operation. In cold or when the engine is cooled down, never open the choke lever suddenly. (9) Rotation of the engine speed stabilizes and when from low speed making at high speed rotation, if reaches the point where it accelerates smoothly, it is completion of warming-up. To adjust the engine speed, set the cruise control lever to the "OFF" position once, adjust the engine speed with the trigger lever again, then set and fix the cruise control lever to the "ON" position. Operation of the trigger lever with the cruise control lever in the "ON" position may cause failure. The lower portion of the fuel tank acts as an assist handle, which enables operation with both hands. Do not allow kerosene, gasoline, or lighted cigarette to be sucked into the machine. Do not allow foreign materials, such as large wood chips, metals, glass, pebbles, etc. (1) Opening/closing the plug cover When opening the cover, apply fingers to the main handle and plug cover projection as shown in the figure right. Push up the projection and slide the cover in the "OPEN" direction. When closing the cover, slide the cover in the "CLOSE" direction till the click under the plug cover projection rides over the engine cover. (2) Removing the spark plug Use an attached box wrench to remove or install the spark plug. (3) Checking the spark plug The clearance between two electrodes of spark plug (see the figure left) is 0. Clogged fuel filter may cause difficulty of startup or failure of engine speed increase. (3) If the fuel filter surface is contaminated, clean it with gasoline. Foul gasoline must be disposed of according to the method specified by each local authority. In reassembling after the engine is dismounted, be sure to replace the gaskets and packings with new ones. Any maintenance of adjustment work that is not included and described in this manual is only to be performed by Authorized Service Agents. When draining the fuel, be sure to stop the engine and confirm that the engine cools down. [. . . ] DEFECTS WARRANTY REQUIREMENTS: (a) The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser. Dolmar must warrant to the ultimate purchaser and each subsequent owner that the engine or equipment is: (1) Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board; and (2) Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years. (c) The warranty on emissions-related parts will be interpreted as follows: (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b)(2). If any such part fails during the period of warranty coverage, it must be repaired or replaced by the manufacturer according to Any such part repaired or replaced under the warranty must be warranted for the remaining warranty period. [. . . ]