User manual DOLMAR ES-35 PARTS LIST 3-00

[. . . ] In order to guarantee the optimal function and performance of your electric chain saw and to ensure your personal safety we would request you to perform the following: Read and understand this instruction- and safety manual carefully before putting the electric chain saw into operation for the first time. Failure to do so can result in serious injury to the operator and/or bystanders!Prolonged periods of operation can cause circulatory problems in the use`s hands due to vibration. For such use, it may be appropriate to use a saw having an anti-vibration feature. [. . . ] Check the chain tension frequently - new chains tend to get longer during use!When checking the chain tension the motor must be switched off and the power supply plug pulled out. If the chain is too loose: Loosen the sprocket guard quick tightener by about a quarter turn. tighten the chain as described under "Tighteneing the saw chain. " HINT: Use 2 or 3 saw chains alternately for even wear of the chains, sprocket and guide bar running surfaces. In order to guarantee a uniform wear of the groove in the bar the bar should be turned over whenever replacing the chain. The electric chain saw comes with an chain brake as standard equipment. The next time you use the saw, fill the tank with BIOTOP chain oil again. In case of damage caused by using waste oil or unappropriate chain oil the product guarantee will be null and void. The residues in the waste oil result in a high degree of wear and tear at the oil pump and the sawing device. In the case of damage caused by using waste oil or unappropriate saw chain oil the product guarantee will be null and void. When the chain brake is actuated the power supply to the motor will be cut off. If the saw does not start when the ON/OFF switch (1) is actuated, it will be necessary to release the chain brake. Pull the hand guard (6) firmly in the direction of the arrow until you feel it catch. This electronic component prevents too abrupt starting of the electric motor. Excess current cutoff: When the electrical current to the saw exceeds the permissible level, the power supply to the motor is automatically cut off. To start the saw up again, release the ON/OFF switch and press it again. CAUTION: Do not use the saw if the current cutoff repeatedly switches off the saw. Do not work with the chain saw without first checking the chain brake!- Grasp the tubular handle firmly with one hand and hold the grip with the other. - Start the motor as described (make sure you have a good footing, and place the chain saw on the ground in such a way that the guide bar is free of contact). - Switch on the motor and press the hand guard (1) in the direction of the arrow with the back of your hand until the chain brake engages. [. . . ] To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by DOLMAR Authorized or Factory Service Centers, always using DOLMAR replacement parts. Malfunction Chain saw does not work System total Observation electric motor does not function Cause no power supply, cable defective chain brake actuated Mains fuse blown Carbon brushes worn down oil tank empty, oil guide groove dirty Brake band worn down Carbon brushes worn down Low pulling power no oil on the saw chain Saw chain does not stop instantly Saw chain continues to run To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. The user of the electric chain saw is not allowed to perform maintenance works which are not described in the instruction manual. [. . . ]