User manual DOLMAR BC-250 PARTS LIST

[. . . ] Transmitter/Outdoor unit Insert x alkaline LR6/AA batteries in the transmitter (making sure all the batteries are correctly inserted according to the markings in the battery compartment). The indicator on the front of the unit is lit for approximately 4 sec. Make sure to insert the batteries according to the markings in the battery compartment. Do not move the display before data has been received from the transmitter; otherwise the transmitter will go into search mode. [. . . ] Touch the same section again in order to set the alarm to sound for high indoor temperature. Change the values with the "+" and "­" buttons or turn off the alarm with the ON/OFF button. Touch the same section a third time in order to set the alarm to sound for a low indoor temperature. Use the "+" or "­" to change between outdoor temperature, wind chill factor and dew point. Use either "+" or "­" in order to change between displaying C (Celsius) and F (Fahrenheit). Touch the same section a third time in order to set the alarm to sound for high outdoor temperature. Change the values with the "+" and "­" buttons or turn off the alarm with the ON/OFF button. Touch the same section a fourth time in order to set the alarm to sound for a low outdoor temperature. Change the values with the "+" and "­" buttons or turn off the alarm with the ON/OFF button. Touch the same section again in order to set the alarm to sound for high humidity. Press the same section for a third time in order to display the highest measured humidity. Press the clock a third time using "+" and "­" to set the clock's display for a 1 or 4 hour time display. Use "+" and "­" to shift between displaying the alarm time, date or weekday. Press "+" and "­" in order to change the date format DD-MM or MM-DD (the display shows dM or Md depending on which format is chosen). Press the date display a third time causing the year display to flash. Memory: The memory symbol MEMORY on the bottom part of the screen shows how much memory has been used for weather data history. The weather station can save up to 4080 readings complete of complete weather data, including the time and date. The weather data is saved in EEPROM and is therefore unaffected if the battery is taken out (during battery change). If the memory capacity is overrun the oldest information is automatically replaced by the new reading. press "­" to show previous readings or "+" to show later readings. Press and hold this symbol for approximately 3 seconds to clear the memory. This makes possible the transfer of data from the weather station to PC and allows for statistic and in-depth analysis. [. . . ] When the weather station is connected to the computer the is disconnected the icon is shown instead. This section is used to set up PC software display, base station units, as well as able or disable the corresponding alarm function. Make desired settings and push Save to save the settings or Cancel to cancel without saving. Clear Memory: Erases all saved weather data in the weather station's memory Shows a graph over saved weather data Export: Cancel: Exports weather data to an external program Cancel and close the window If you want to save the archived data you can copy the file EASYWEATHER. [. . . ]