User manual DOLMAR 114 PARTS LIST 3-1987

[. . . ] For the components listed under PARTS COVERED, the service dealer authorized by DOLMAR will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ] Before long-term storage and before shipping the Power Cut, follow the instructions in the chapter on "Periodic care and maintenance". When putting cutting discs in storage, be careful to: · Clean and dry them well. CAUTION: Do NOT clean synthetic resin cutting discs with water or other fluids!Before re-using a resin cutting disc, make sure of the use-by (expiration) date (quarter and year, stamped on the arbor ring). Always check new cutting discs or cutting discs that have been in storage to make sure that they are free of defects and before the first cut test-run the tool at top speed for at least 60 seconds. Keep body parts and people well away out of range of the direction of the cutting disc during this test. Before performing maintenance work switch off the Power Cut (27) and pull out the plug cap. Allow the Power Cut to cool off before doing any maintenance work (burn hazard)!Always check the Power Cut before using it to make sure that it is in good working order. Make sure that the cutting wheel is undamaged and suitable for the job it will be used for. Perform only the maintenance and repair works described in the instruction manual. NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise the cutting wheel may slip during cutting. If the Power Cut is new or the V-belt has been replaced, retighten the V-belt after the first hour of operation!NOTE: The two fastening nuts (11) must be loosened before tightening the V-belt or checking the tension. To increase the belt tension, turn the tightening screw (12) to the right (clockwise) with the combination wrench included with the Power Cut. After tightening/inspection, make certain to tighten the fastening nuts (11) (30 ± 2 Nm). CAUTION: Before doing any work on the Power Cut, always switch off the engine and disconnect the spark plug cap!NOTE: When using a protective hood for a maximum disk diameter of 300 mm (12"), always shorten hose (15) to 180 mm (7"). To do this unscrew sleeve (16) and carefully pull tube (15) off coupling (17) and cut to 180 mm. Then push the tube end back over the coupling and tighten the sleeve all the way. Push clamp (22) around the front grip (23) and fasten with the bolt and square nut. Pull the quick-release coupling (24) from the water connection and connect it to the 1/2" supply line (18). [. . . ] We therefore recommend that you consult a DOLMAR service center for all work not described in this instruction manual. The DOLMAR service centers have all the necessary equipment and skilled and experienced personnel, who can work out costeffective solutions and advise you in all matters. Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly provide you with the address of your nearest DOLMAR service center. Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts used. [. . . ]