User manual DISCOVERY CHANNEL STX7000

[. . . ] Indd 1 2012-02-13 �� 9:36:22 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION NO Error Code (Diagnostic Code Error Image) nd Description Corrective Action 1 The water level fails to drop below the Go to “ Will Not Drain” Troubleshooting Reset Water Level within 30 minutes. 3 nF When the filling Continues for more Go to “ No Water Fill” Troubleshooting than 60 minutes or there is no change Section. 4 FL 5 LE A water level lower than the Reset water level is detected for 5 seconds during the Wash/Rinse cycle. [. . . ] If no key is operated during Service Mode for 5 minutes, the machine will return to normal user mode. Quick Spin Test Mode: As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM. Once the Spin speed reaches the maximum RPM, the speed drops immediately. to hold Quick Spin Test Mode (entering Hold Speed Mode) , press the Start/Pause button. If the Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its spinning speed for 10 minutes before going back to Quick Spin Test Mode. Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the Delay Start and Temp Keys together for 3 seconds. Keys for three (3) seconds when the washing machine is not in Hold Speed Mode, Quick Spin Mode is exited and Service Mode is restored. Indd 7 2012-02-13 �� 9:36:24 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. cycle Count Check Mode Definition of Cycle Count Check Mode: - Cycle Count Check Mode is to tally up the number of washings. How to Enter: - To enter the Cycle Count Check Mode, press the Signal Key during Service Mode. When the Signal key is pressed, the total number of washings will light up and a signal LED will glow. How to Enter: - To enter the Diagnostic Code Check Mode with code “d” flashing, press the Spin key during Service Mode. Press the “Spin key” key to start Error Code Check Mode with Code “d” flashing. To cycle through the error codes, turn the Rotary Cycle Selector in one direction (either Clockwise or Counterclockwise). Now, when turning the Rotary Selector Key in the same direction, it shows error codes from the latest. When turning it in the opposite direction, it shows the error codes in the reverse order. spin Diagnostic Code 11 STX7000_03051A-02(Technical information). Indd 11 2012-02-13 �� 9:36:25 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. Demo Mode - Demo mode is entered when the Pure Cycle + Extra Rinse buttons are held down for five (5) seconds simultaneously in the power on state. - When entering Demo mode, the buzzer rings three (3) times and “- - - -” is displayed on the 7 segment display and all other LEDs are turned off. (Initial Demo mode) - Demo mode consists of WASH , SPIN and LED modes. - If the Temp button is pressed during the initial Demo mode, “WASH” blinks on the 7 segment display and the washing machine enters WASH mode. [. . . ] €¢ Reduce the amount of detergent for that specific load size and soil level. €¢ Reduce the amount of detergent when water is soft, or laundry is small or lightly soiled. €¢ Do one more washing cycle with cold water and a table spoon of salt without detergent. 2 ohm between the terminal of contact (white-Red wire), and if not, change pcb(refer to pcb connector check). [. . . ]