User manual CURTIS RCD631

[. . . ] Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 2. l l l l l l 3. 4. 5. l This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL 6. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. 7. 8. WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DRIPPING WARNING The product shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the product. [. . . ] Safety Check ­ Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Heat ­ The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that product heat. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 16. Power Lines ­ An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal. Overloading ­ Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry ­ Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock. Above all l l l NEVER let anyone, especially children, push anything into holes, slots or any other openings in the case this could result in a fatal electric shock. Press LINE IN (29) on the remote control while display indicates "LINE". Connect one end of a RCA plug signal wire (not included) to Subwoofer Socket (17) and the other end of wire to your subwoofer. AC Outlet Mains connection This system is designed to operate on AC110V-127V ~60Hz house current. Connecting this system to any other power supply could result in damage to the unit, which is not covered by your warranty. If this plug will not fit into your outlet, you should have your outlet changed by a qualified licensed electrician. As soon as the unit has been connected with the mains voltage, parts of the unit are in operation due to the standby function. To switch off the unit completely pull the mains plug. 46 47 41. Button POWER Button CD DOOR Open/Close Button Number 0-9 Button +10 Button PROGRAM Button VOL Button AC Plug -8- -9- CLOCK AND TIMER CLOCK 1. To cancel Timer On setting, press MODE (31) several times until you reach the Timer On setting mode. To cancel Timer Off setting, press MODE (31) several times until you reach the Timer Off setting mode. [. . . ] Volume at minimum. Reposition the unit until best reception is obtained. Increase Volume. Compact Disc Player CD Player will not play. CD skips while playing. Function inoperative and jammed Display no indication or abnormal indication Unit not in CD function mode. Use a sharp tip to press into the reset hole to reset the built-in microcomputer. [. . . ]