User manual CATEYE SOLO

[. . . ] Note: Securely connect the jack to the plug. lamp unit 6v READ ALL INSTRUCTIONS BEFORE FIRST USE Copyright© 2000 CAT EYE Co. , Ltd. HLMRC22/23-011120 066640001 HOW TO USE ON/OFF The remote switch controls the operation of the lamp unit. ·Twin (HL-RC230) ----- Button 1: on/off of lamp1 Button 2: on/off of lamp2 ·Solo (HL-RC220) ----- Button 1: 10W(HI)/5W(LOW) Button 2: on/off Note: 5-watt beam is produced by adjusting the voltage of 10 watt output. 4 Thank you for purchasing the CAT EYE Daylits II rechargeable head lamp. [. . . ] (Depending on the capacity of the battery, the charging time will vary. ) Be careful not to charge it for more than 10 hours. Standard charging time Note: The charging time and the operation time may vary hours depending on the use environment. the home power outlet 8-10 Precautions on seald-lead-acid battery · If the light is kept on until the power is completely gone, the performance of the battery is lowered due to the overdischarge of the sealed-lead-acid battery. When the light gets dim, turn off the lamp immediately and charge the battery. · A long period of non-use will lower the voltage of the battery due to natural self-discharge. If the light is kept on until the power is completely lamp body bulb WARNING!!Important Note gone (which is called "overdischarge"), it may shorten the battery life. Even when you do not use the lamp kit, charge the battery every few months. · If the lamp set does not serve the proper running time even though the battery is fully charged, the battery may have reached the end of its useful life. Replace it with a new battery unit (BA-220). IMPORTANT HOW TO REPLACE THE BULB When replacing the bulb, be sure that the bulb and the lamp body have cooled. Use only the CAT EYE 6V-10W Halogen Bulb (product code #534-0580/534-0581). Tighten the lock ring securely while being careful of the waterproof packing. BEFORE FIRST USE: Before first use, charge the battery fully following the instructions on [HOW TO CHARGE]. Before every use, charge the battery fully following the instructions on [HOW TO CHARGE]. When the battery kit is not in use for a long period, the lampís operation time will be shortened due to the self-discharge of the sealed-lead-acid battery. bracket (H-30) waterproof packing lock ring pull HOW TO ATTACH THE BRACKET [Use two brackets for Twin. ] 1. Attach the bracket (H-30) to the handlebar using the appropriate rubber pads provided. Before use, adjust the angle of the beam and the position of the lamp unit, according to the instruction of "How to Adjust Angle of Beam" in "HOW TO USE". rotate 8A fuse fuse case HOW TO REPLACE THE FUSE A fuse will cut the circuit when malfunction occurs. Note: If the fuse continues to burn, call the appropriate service center for assistance. [. . . ] Address for service: 2-8-25 Kuwazu, Higashi Sumiyoshi-ku Osaka 546-0041 JAPAN Attention: CAT EYE CO. , LTD. Customer Service Section Phone: 81-6-6719-7781 Fax: 81-6-6719-2362 Service & Research Address for United States Consumers: CAT EYE Service & Research Center 1705 14th St. #115 Boulder, CO 80302 Phone: 303-443-4595 Toll Free: 800-5CATEYE(800-522-8393) Fax: 303-473-0006 e-mail: service@cateye. com web site: http://www. cateye. com battery belt Mounting the Lamp Unit lamp unit slide lever bracket Warning!: Never touch the lamp body until it is thoroughly cooled. [. . . ]