User manual CATEYE HL-EL820RC

[. . . ] Secure the cable on the rear of the helmet using the spare cable strap. To remove the light unit, pull the light unit forward while pressing the button on the base of the light unit. CAUTION!: Make sure the light unit is cool to the touch before removing it. Bracket strap 0 3 Connecting the extension cord Connect the extension cable. Connect the extension cable between the light unit and the battery unit as shown in the figure. [. . . ] CAUTION!: · Pay attention to the arrangement of the cable so that it does not interfere with the handling of the bicycle. Do not secure the cable at an acute angle because the wire inside the cable may break. · Adjust the beam angle according to "How to Adjust the Beam Angle" in this manual. Gear & Brake Cables Top tube 0 9 2 HOW TO USE A Switching on/off A Switch Use the switch to switch between Hi and Low beams. 2 hours (Hi mode) Press: Hi Low Hi * The run time varies with the environment or conditions in which it is used. Long press: Turn off B How to Adjust Beam Angle Adjust the beam angle to avoid dazzling oncoming traffic by slightly loosening the dial of the bracket. NOTE: · Do not loosen the dial too much, or the bracket strap may come off. · It can also be adjusted 10 degrees to the left and right. B 2 C Remaining battery 1 The color of the battery indicator built into the switch shows how much battery is left. NOTE: When the battery indication becomes red, charge the batteries as soon as possible. Guigeline for the battery indicator Green Yellow Red : More than 50% left : 50 to 20% left : Less than 20%. Charge the battery unit. C Charging Indicator To AC Power Outlet * The battery indicator is only an estimation of the remaining battery run-time, and varies with the environment or conditions of use. 4 2 How to Charge Battery unit Important! · If the battery unit is wet, wipe dry with a dry cloth before charging the batteries. · If the charging indicator flashes green, there is a short somewhere in the circuit. · If the charging indicator turns green a few minutes after charging begins or if the indicator continues a fast green flashing, stop charging, unplug the charger from the outlet, and do steps 1 and 2. If the same result occurs repeatedly, the batteries may be deteriorated. · The standard charging time and run time are guideline values and depend on the operating environment. · If the battery unit repeatedly does not meet the proper run time even though it is fully charged, it might be at the end of its operating life. The used battery unit should be disposed of properly according to local regulations. NOTE: Check that the charging indicator flashes red three times as the power lamp turns red. Connect the plug of the battery charger to the plug of the battery unit. · When charging is complete, the indicator light changes from flashing red to green. After charging is complete, make sure to unplug the charger from the AC outlet. Ring LOCK SPECIFICATIONS Two High-Power White LEDs Rechargeable lithium-ion battery/7. 4V, 2300mAh CHR-2300/4600mAh Li-ion (AC100V-240V 50/60Hz) Approx. 3 hours Temperature range --------- Charging : 41°F ­ 104°F (5°C ­ 40°C) Operating: 5°F ­ 113°F (-15°C ­ 45°C) Recharge/discharge number of times -------------------------------- About 300 times (until the rated capacity drops to 70%) * The specifications and design are subject to change without notice. [. . . ] · Place the swich at least 20 cm away from any wireless meter, as transmitting and receiving performance may be adversely affected. #533-8827 #534-1831 UL: #037-5895 UK: #037-5896 EC: #037-5897 AS: #037-5899 #534-1848 #534-1847 #534-1860 LIMITED WARRANTY 2-year Warranty : Light Unit, Battery Unit, Battery Charger (Excluding degradation of the battery unit) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly on the warranty certificate, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. CO. , LTD. [. . . ]