User manual CARVIN LC24

[. . . ] This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. LIMITED WARRANTY Your Carvin product is guaranteed against failure for 1 YEAR unless otherwise stated. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Carvin assumes no responsibility for horn drivers or speakers damaged by this unit. This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. [. . . ] We strongly recommend that you read this manual to fully understand the potential of the LC24 light console. RECORDING MODE: FEATURES, HOW TO, AND EXAMPLES A. TO ENTER RECORDING MODE: Press and hold the RECORD button, now press­in sequence­the channel FLASH buttons 1, 5, 6, and 8 while still holding the RECORD button. RECORDING A SCENE PROGRAM: (A four step chase program saved into scene program location 28. ) · Enter Record mode: See A. * Set the mode LED's to 1x24 (or 2x12 depending on the light system used) Programming steps: · Raise the CHANNEL 1 FADER to max. · Now raise the CHANNEL 2 fader to max · Press the RECORD button once. · Lower the CHANNEL 2 FADER to min · Repeat for CHANNEL 3 and CHANNEL 4 FADERS. The display should increment each time the record button is pressed corresponding to the current step recorded. · To start over in a program, Press and hold the RECORD button and press the REC CLEAR button. Now the memory is cleared and the next step recorded will be step one of the new program. Storing the program · Press the PAGE button until the page LED over the "3" is lit. 11. ) HOME BUTTON In the Scenes mode this button, when activated, returns the SCENE FADERS and FLASH BUTTONS to controlling the Scene programs. 12. ) FADE FADER This fader adjusts the time a controlled light takes to go from the off to maximum intensity and the same time is used for going from maximum to off. 13. ) TAP SYNC BUTTON This button is used as an alternate way to define the chase speed in Scenes mode. When tapping this button the time between the last two taps is the new chase speed. 14. ) SPEED FADER, 5MIN LED, & 10MIN LED This fader adjusts the chase speed in the Scene mode. Slowest speed is define in the two LED's above the fader 5min or 10min. To change the lowest speed to 5 minutes press and hold the RECORD button. While holding the RECORD button down, press channel 5's FLASH button three times. To change the lowest speed to 10 minutes press and hold the RECORD button. While holding the RECORD button down, press channel 10'S FLASH button three times. 15. ) FULL ON button When pressed all channels with output at full intensity over ride black out mode while pressed. 16. ) AUDIO FADER This fader controls the sensitivity of the internal microphone and audio input jack. [. . . ] Press and hold the REC SPEED button along with the Scene programs FLASH button upon release of both buttons the control is restored. 26. ) DARK BUTTON The DARK button is like a momentary version of the BLACKOUT button. Except the DARK button cannot be over ridden by any other button while still pressed. 27. ) ALL REV BUTTON / EDIT The ALL REV button works in the Scenes mode. [. . . ]