User manual BOSCH WTL6301EU

[. . . ] WTL 6301 en Instruction Manual and Installation Instructions Table of Contents Operating Instructions Your new dryer . 4 5 5 5 6 6 6 7 7 7 8 8 9 9 10 11 12 13 13 13 14 15 15 15 16 17 17 18 18 18 18 2 End of the programme . . 19 19 19 20 20 20 21 22 23 24 25 28 29 30 30 30 31 32 32 33 33 34 38 Installation Instructions 3 Your new dryer With the purchase of your new dryer, you have cho sen a modern, high quality domestic appliance. Every dryer which leaves our factory is carefully chek ked to ensure that it functions correctly and is in per fect condition. [. . . ] Turn the programme selector to Off. 20 Cleaning the fluff filter Bobbling (fluff) occurs as clothes etc. These bobbles come off during the drying cycle and collect in the fluff filter. A clogged filter results in longer drying times and higher energy consumption. If the Filter o" indicator lamp comes on and a buzzer sounds while the dryer is on, clean the filter immedia tely. Allow the dryer to cool slightly and then clean the filter as described above. i Very dirty or blocked filters should be rinsed under warm running water. The filter must be dried thoroughly before being replaced. 21 Empty the water container dDo not drink this water. Condensation accumulates during drying. If a large amount of washing which has not been thoroughly spun is dried at the same time (more than 5 kg at less than 1200 rpm), it may be necessary to remove some of the washing mid-cycle. If the Water p" indicator lamp lights up and a buzzer sounds while the dryer is running, the container must be emptied within 90 minutes. After 90 minutes have passed, the status indicator will display End", but the laundry will not be dry. The programme starts again from the beginning. 22 Cleaning the condenser unit The condenser unit should be cleaned three or four times a year, or more often if the dryer is used very frequently. Residual water may leak out so place an absor bent towel underneath the maintenance flap. Turn both locking levers towards each another (in the direction of the arrows). Pull out the condenser unit. dTake care not to damage the condenser unit. Only use water to clean the condenser unit. 11. Press the maintenance flap evenly on the right and left until it engages in place. i The door will only close if the maintenance flap is properly closed. 23 Changing the bulb for the interior light You will need a special tool and a new bulb. - 15 watt bulb for E14 oven. dDanger of death Danger of death from electrical voltage. Screw the light cover back on carefully (using mo derate force). dDo not use a power screwdriver. dDo not use appliances with open, faulty or missing light covers. 24 What to do if . . . dDanger, electrical current. Repairs must only be carried out by the after sales service or an authorised expert. If you cannot rectify a fault yourself, or a repair is ne cessary: q Turn the programme selector to Off. The Mu" indicator llamp d does not come on. Cause The dryer is not plugged in. The ambient temperature is below 5 ºC. Solution Plug in the dryer. [. . . ] The door is hinged on the right at the factory (see page 34). 30 Electrical connection Caution: The dryer must be connected correctly to an A. C. The mains voltage must comply with the voltage information given on the identification plate (on the rear of the unit). The connected load and the necessary fusing are shown on the identification plate. If the mains cable needs altering, this should only be done by the after sales service. [. . . ]