User manual BOSCH WTL6103GB

[. . . ] Your local dealer or local authority will be able to advise you about the disposal methods which are currently available. 5 Safety information Using your dryer correctly - Only for domestic use. - Do not leave children unsupervised near the dryer. dRisk of explosion/fire Solvent danger. Do not use the dryer if: - the laundry has been treated with a solvent or has been colour treated (e. g. Dust danger Do not use the dryer if: - the laundry contains dust, e. g. [. . . ] Turn the programme selector to Off. 19 Cleaning the filter Bobbling (fluff) occurs as clothes etc. These bobbles come off during the drying cycle and collect in the fluff filter. A clogged filter results in longer drying times, higher energy consumption and is indicated by a flashing cupboard dry display. Close the door. Cleaning the moisture sensors A thin layer of limescale may build up on the moisture sensors on the inside front wall of the appliance after long periods in operation. i Do not use steel wool or abrasive cleaning agents. 20 Empty the water container dDo not drink this water. Condensation accumulates during drying. If a large amount of washing which has not been thoroughly spun is dried at the same time (more than 5 kg at less than 1200 rpm), it may be necessary to remove some of the washing mid-cycle. water" indicator lamp lights up and a buzzer sounds while the dryer is running, the contai ner must be emptied within 90 minutes. After 90 minutes have passed, the status indicator will display anti crease/End", but the laundry will not be dry. The programme starts again from the beginning. 21 Cleaning the condenser unit The condenser unit should be cleaned three or four times a year, or more often if the dryer is used very frequently. Residual water may leak out so place an absor bent towel underneath the maintenance flap. Turn both locking levers towards each another (in the direction of the arrows). Pull out the condenser unit. dTake care not to damage the condenser unit. Only use water to clean the condenser unit. 11. Press the maintenance flap evenly on the right and left until it engages in place. i The door will only close if the maintenance flap is properly closed. 22 What to do if . . . dDanger, electrical current. Repairs must only be carried out by the after sales service or an authorised expert. If you cannot rectify a fault yourself, or a repair is ne cessary: q Turn the programme selector to Off. Push the door until you hear a click as the locking catch engages. The Start/Stop" indicator The dryer is not plugged in. The catch is not engaged. 23 What to do if . . . Cause Solution Clean the fluff filter and the condenser unit (see pages 20 and 22). Restart the programme. One or more programme There has been a fault in the status indicator lamps are programme sequence or operation. g The maximum drying time for the programme has been exceeded. Clean the fluff filter and the condenser unit (see pages 20 and 22). Spin the laundry in the washing machine at the maximum spin speed. The humidity in the room has increased significantly. The condenser unit has not been inserted. Ensure sufficient ventilation. The contents did not dry or the drying time was too t llong. Cause The condenser unit is clogged. [. . . ] They could other wise be overtightened. dDo not use a power screwdriver. To remove the door: !Remove both door fastening point covers: Lever them off carefully with a slotted screwdriver. Undo both of the screws which are underneath and screw them in on the opposite side. 3. Replace the cover and screw it back on. 33 Converting and replacing the door. [. . . ]