User manual BOSCH SKS60E12EU

[. . . ] Dishwasher 9000 451 590 (8908) en Operating instructions Reset 3 sec. 9 8 7 Start 1 2 3 4 5 6 20 21 22 23 24 25 26 27 28 en Table of contents Washing the dishes . 13 13 13 13 13 14 14 14 14 14 14 15 15 15 15 16 16 17 17 17 18 18 19 19 19 20 20 20 20 20 21 21 21 21 22 22 22 Safety instructions . 13 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. [. . . ] Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Changing the programme When the START button 8 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). End of programme The programme has ended when the value : is indicated on the numerical display @. Intensive drying The final rinse uses a higher temperature which improves the drying result. ­ Rotate programme selector 0 until : is indicated on the digital display @. The factory-set value : is lit on the digital display @ (intensive drying off). Change the setting as follows: ­ By rotating the programme selector 0, you can switch intensive drying on : or off : . The set value is saved. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 14 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1* keep large foreign objects in the rinsing water away from the pump. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ Unscrew filter cylinder as illustrated and take out filter system. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid ­ Check the refill indicators ` and X. If required, refill salt and/or rinse aid. ­ Remove any residue and clean filters under running water. ­ Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 15 en Spray arm Limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". ­ Remove the spray arm upwards. Waste water pump Large food remnants in the rinsing water not retained by the filters may block the waste water pump. [. . . ] ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. Please note the system will not function unless the power supply is connected. Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: ­ Turn on the tap. [. . . ]