User manual BOSCH POF 1400 ACE REV 8-2009

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Router bits made of high speed steel (HSS) are suitable for the machining of soft materials, e. Original router bits from the extensive Bosch accessories program are available at your specialist shop. ­ Loosen the tightening nut 25 with the openend spanner 26 (size 19 mm) by turning in rotation direction . The shank of the router bit must be immersed at least 20 mm into the collet. ­ Tighten the tightening nut 25 with the openend spanner 26 (size 19 mm) by turning in rotation direction . Do not insert a router bit with a diameter larger than 50 mm when the guide bushing is not mounted. Do not tighten the tightening nut of the collet without a router bit inserted. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until 28 Dec 2009), 2006/42/EC (from 29 Dec 2009). Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be harmful to one's health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or bystanders. Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-treatment additives (chromate, wood preservative). It is recommended to wear protective gloves when inserting or replacing router bits. Depending on the application, router bits are available in the most different designs and qualities. Mounting the Extraction Adapter The extraction adapter 28 can be mounted with the hose connection to the front or to the rear. For deep cuts, it is recommended to carry out several cuts, each with little material removal. By using the step buffer 9, the cutting process can be divided into several steps. For this, adjust the desired depth-of-cut with the lowest step of the step buffer and select the higher steps first for the initial cuts. POF 1200 AE: The clearance of the steps can be changed by screwing the adjusting screws 24 further in or out. Fine Adjustment of the Depth-of-cut (POF 1400 ACE) After a trial cut, the depth-of-cut can be set exactly to the desired measure by turning the adjustment knob 18; turn in clockwise direction to increase the cutting depth and in anticlockwise direction to decrease the cutting depth. , a piece of scrap wood under the guide plate 7 so that the router bit 21 cannot touch the workpiece when lowering it. Push clamping lever 16 in rotation direction and slowly lower the plunge router until the depth stop 13 faces against the step buffer 9. [. . . ] Because of the projecting height of the guide bushing, the template must have a minimum thickness of 8 mm. Actuate the release lever 20 and insert the guide bushing 43 from below into the base plate 6. ensure that the encoding keys clearly engage in the grooves of the guide bushing. Select a router bit with a diameter smaller than the interior diameter of the guide bushing. [. . . ]