User manual BOSCH POF 1100 AE

[. . . ] B) Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. E) When operating a power tool outdoors, use an extension cord suitable for outdoor use. [. . . ] A complete overview of accessories can be found in our accessories program. Plunge router Article number Rated power input No-load speed Speed preselection Constant electronic control Connection for dust extraction Tool holder Plunge depth Weight according to EPTA-Procedure 01/2003 Protection class mm inch mm kg 6/8 ¼ 55 3. For lower voltage and models for specific countries, these values can vary. Typically the A-weighted noise levels of the product are: Sound pressure level 95 dB(A); Sound power level 106 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. English | 23 An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Insert the chip shield 5 from the front into the guide in such a manner that it engages. To remove the chip shield, grasp it by the sides and pull it off toward the front. To start the machine, first push the lock-off button for the On/Off switch 1 and then press the On/Off switch 22 and keep it pressed. Note: For safety reasons, the On/Off switch 22 cannot be locked; it must remain pressed during the entire operation. Constant Electronic Control (POF 1100 AE) Constant electronic control holds the speed constant at no-load and under load, and ensures uniform working performance. If required, push the clamping lever 16 in rotation direction to lock it in place. ­ Push the depth stop 13 downward until it rests on the step buffer 9. Pay attention not to misadjust the slide with the index mark 12 again. ­ Check the selected depth-of-cut by carrying out another trial cut. After adjusting the depth-of-cut, do not change the position of the slide 12 on the depth stop 13 any more, so that the actual cutting depth can be read on the scale 14. Fine Adjustment of the Depth-of-cut (POF 1200 AE) Different depths-of-cut can be preset with the step buffer 9. [. . . ] Guide the switched on power tool over the workpiece with the right handle 2 and the router compass handle 36. Routing with Guide Rail (see figure N) Straight routing cuts can be carried out with help of the guide rail 41. The base spacer 42 must be mounted in order to compensate the height difference. Place the machine with the guide-rail adapter 35 mounted onto the guide rail. [. . . ]