User manual BARAZZA 1KBDD12

[. . . ] The person who is mounting the hood should make sure that the fixing elements are right and suitable for the walls and ceilings he finds. The manufacturer declines any responsibility for damages caused by incorrect mounting. Before the fist use pay attention to what has been written in the attached manual. The accessibile parts of the hoods can become hot if the hob is working. [. . . ] After filter maintanance has been carried out you have to: Stop the motor (stop position); Press twice in succession the push button, to confirm that reset has been made the symbol is appearing in the display and a "beep" is issued. If you wish to use the hood as filtering (saturation indicator and ) please do the following: Press at the same time for ca 5 seconds the push buttons + , in the Display you will have the symbol followed by an acoustic signal. To reset the hood just for suction use, repeat the above, in the display you will have the symbol appearing. If you keep on pressing the light Push button disactivate the secondary lights. For more than 1 second you activate/or The motor is switched on automatically 10 minutes each hour at the speed flashing in the display. Press at the same time the push buttons will show 1; And , then release them: the display If you press the push button , the display will show the following numbers for the speeds of the motor 2312 . Press at the same time the push buttons and to confirm the speeds at which the interval function will be activated. Deactivate: you can deactivate pressing any push button but not the light push button. Additional Functions: MICROSWITCH for hoods with movable front parts or drawers. If you open or close a door or if you pull out a drawer according to the kind of cooker hood (which is always an advised operation if the fires are on) the motor is starting at the second speed; all functions of the controls are allowed. In order to increase the conformt of the end user this hood is equipped with a sensor which after reaching 40° is setting the speed in automatic way according to the intensity of the fires. If you activate the AUTOMATIC FUNCTION the display will show the letter alterning it with the speed set. With the flashing letter it is not possible to switch the motor off, but it is possible to change the speed; anyway after 10 minutes the AUTOMATIC FUNCTION will be restored. The motor is switching on in automatic way when the 40° are reached and it switches off automatically when the temperature goes under that limit. If the motor is switched on in a manual way it has to be switched off in a manual way only and if the temperature is under 40° ( letter not flashing). It is forbidden to leave the fires on if not covered by pans or covered with emty pans. It sets the highest speed of the motor which is shown by a and after 5 minutes the second speed is automatically set. Press the button to confirm the choice effected in the previous point. 1 and the led of the push button is switched on, if the first speed is already on, the led of the push button will flash and the motor stops automatically after 10 minutes. 2 and the led of the push button is switched on, if the second speed is already on, the led of the push button will flash and the motor stops automatically after 10 minutes. 3 and the led of the push button is switched on, if the third is already on, the led of the push button will flash and the motor stops automatically after 10 minutes. It sets the highest speed of the motor and the led of the push button will flash and after 10 minutes automatically the hood goes back to the second speed. [. . . ] carbon filters that can be regenerated: Please follow and read the instructions given with the carbon filters that can be regenerated as far as mounting and re generation are concerned. carbon filters that cannot be regenerated: We advise to replace the carbon filters after circa 200-300 hours of use of the cooking top. The carbon filters that cannot be regenerated cannot be either washed nor regenerated but need to be replaced when expired. To ensure correct ventilation and air interchange in the kitchen, national and international regulations exist, which should be respected. [. . . ]