User manual AUDIOLINE TEL5CLIP

[. . . ] 3 Private branch exchanges The telephone can also be connected to a private branch exchange. Ask the dealer where your private branch exchange was purchased whether the telephone will function properly on the private branch exchange. There is no guarantee that the telephone will work on every private branch exchange. 4 Information on disposal The implementation of European law in national laws and directives obliges you to dispose of consumable goods appropriately. [. . . ] When the telephone is mounted on a wall, you can hang the receiver on the telephone without cutting off the call. A small hook is located at the top of the receiver rest for this purpose. This completes the entries and the current data will now be shown in the display. Note: If the batteries are fully discharged, the time and date must be re-entered. 1 Making a call Your telephone can be used like any conventional telephone. If the number dialled is longer than this, only the last 14 digits will be displayed. You can end the current call by using the disconnect button and you will immediately obtain a new dialling tone. 2 Receiving calls When a call comes through, you will hear the ringing tone. 3 Call Duration Display The call duration is shown in the display in minutes and seconds during a call. The call duration still remains showing in the display for a few seconds after the call has been ended. 4 Adjusting the receiver volume If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements. 5 Redial facility If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled remains stored in the telephone automatically. to use the redial facility , proceed as follows: Lift the receiver and press the redial button F. 6 Adjusting the receiver volume By means of the slide switch on the right side of the telephone base you can choose the settings (loud) or (soft) to match the volume of the ringing tone to your requirements. If at any time you do not want to be disturbed, use the (off) setting. 7 Storing speed dial numbers Your telephone allows you to store 10 numbers for speed dialling. If the memory location is already occupied, the display will show the message UEBERSCHREIBEN ?If you want to overwrite the memory location, press the S button again. If you do not want to overwrite the memory location, press the disconnect button once and repeat the entire process. 8 Calling up speed dial numbers To call a saved speed dial number, proceed as follows: 1. In the case of incoming calls, you can see who is calling you by means of the caller display facility. [. . . ] Press the F button once between dialling the number for the outside line and the actual phone number. After dialling the number for the outside line, the telephone waits 3 seconds before dialling the actual phone number. 1 Fault finding Remove all extra telephone equipment and connect only the telephone directly to the telephone socket. If the fault is still present, connect another telephone (if available) to the telephone socket. [. . . ]