User manual AUDIOLINE TEL5

[. . . ] The base station must not be installed in damp rooms such as a bathroom or laundry room. Avoid proximity to sources of heat such as radiators and do not expose the unit to direct sunlight. - General information Position Do not set up the telephone in the immediate vicinity of other electrical equipment such as microwaves or hi-fi systems, as this may result in mutual interference. The feet of the telephone do not normally leave any marks on the surface. [. . . ] Drill two holes 85 mm apart, vertically one above the other, and leave the screws protruding 5 mm from the wall. When the telephone is mounted on a wall, you can hang the receiver on the telephone without cutting off the call. A small hook is located at the top of the receiver rest for this purpose. Making a call Your telephone can be used like any conventional telephone. Please follow the instructions: Lift the receiver and wait until you hear the dialling tone. You can end the current call by using the disconnect button and you will immediately obtain a new dialling tone. If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements. If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled remains stored in the telephone automatically. To use the redial facility, proceed as follows: Lift the receiver and press the redial button redial number will now be dialled. By means of the slide switch on the receiver you can (loud) or (soft) to match the volume choose the settings of the ringing tone to your requirements. If at any time you do not want to be disturbed, use the setting (off). You can use the "R" signal button on your telephone on private exchanges and when using DEUTSCHE TELEKOM's T-Net functions. If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer, automatic recall, etc. You can find out from the dealer from whom the equipment was purchased whether your telephone will work on your private exchange without any problems and what further facilities you will receive from this. Dialling telephone numbers when using on private exchanges With private exchanges, it is necessary to dial a certain number (e. "9" or "0") in order to obtain a dialling tone for an outside line on the extension. With some, older private exchanges, it takes some time before the dialling tone can be heard. Especially for these private exchanges, an automatic pause can be inserted after connecting to the outside line so that you can dial directly without waiting for the dialling tone. Press the redial button once between the number for the outside line and the actual telephone number. [. . . ] Any damage caused by improper handling or operation, by incorrect positioning or storage, by improper connection or installation or by excessive force or other external influences is not covered by the guarantee. in the case of complaint , we reserve the right to repair or replace defective parts or to exchange the equipment. Claims for compensation are excluded insofar as they do not relate to criminal intent or gross negligence on the part of the manufacturer. All guarantee claims according to these conditions must be raised exclusively with your dealer. [. . . ]