User manual AUDIOLINE TEL49 CLIP

[. . . ] If you should have any questions, please contact our Service Department on the Hotline number 0180 5 00 13 88. Under no circumstances open the unit yourself and do not try to carry out your own repairs. Intended use This telephone is designed for use connected to an analogue telephone line (PSTN) in Germany. However, due to differences in the services provided by the various telecommunications providers, we cannot guarantee that the telephone will work properly when connected to all telecommunications terminal lines. [. . . ] Confirm with the Enter the current day by repeatedly pressing the buttons. This completes the entries and the current Confirm with the data will now be shown in the display. If the batteries are fully discharged, the time and date must be re-entered. - Setting up Note: If you ever have to change the local or national dialling code at a later date, start programming by pressing the keys simultaneously. You can move the flashing cursor to the desired position by means of the delete button . In order to delete a number altogether, enter a minus sign (-) using the buttons. 8 Setting the display contrast If the display cannot be seen clearly, you can adjust the display contrast to suit the lighting conditions. The display contrast can be adjusted in three steps by means of the "CONTRAST" slide switch on the right-hand side. 9 Private exchanges - T-NET set-up You can use the "R" signal button on your telephone on private exchanges and when using DEUTSCHE TELEKOM's T-Net functions. If you use neither a private exchange or the T-NET-functions of the DEUTSCHE TELEKOM, no adjustments must be made here. Private exchanges If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer, automatic recall, etc. the FLASH time "100ms" (factory setting) will be required on a private exchange. To make this setting, move the slide switch on the right side to the "100ms" position. You can find out from the dealer from whom the equipment was purchased whether your telephone will work on your private exchange without any problems and which other facilities you will have access to. Please contact DEUTSCHE TELEKOM to gain access to these functions (some of which are subject to charge). When using T-NET functions, move the slide switch on the right side to the "300ms" position. 1 Using the telephone Your telephone can be used like any conventional telephone. PLEASE FOLLOW THE INSTRUCTIONS: Lift the receiver and wait until you hear the dialling tone. If the number dialled is longer, only the last 16 digits will be displayed. 2 Receiving Calls As soon as you receive a call you will hear the ringing tone and the visual call indicator will come on at each ring. 3 Increasing the volume of the receiver If the caller's voice should ever be too quiet, you can increase the volume of the receiver. Note: The changed volume setting is not saved and must be increased again for the next call if required. [. . . ] 2 Dialling a telephone number directly from the Caller List You can dial telephone numbers directly from the caller list. With the receiver hung up on base select the required telephone number using the buttons. Before dialling, your telephone compares the country and local dialling codes of the number dialled with your location (local dialling code). If you have entered your local dialling code during installation, the appropriate numbers will not be dialled if this is a number from within your local network. [. . . ]