User manual AUDIOLINE TEL38CLIP

[. . . ] 39 Dialling and storing telephone numbers when using on private exchanges . Batteries Do not use any other kind of rechargeable batteries, as these could possibly lead to a short circuit. When changing the batteries, always use four new batteries, type AAA 1. Do not dispose of old or faulty batteries with the normal household waste. [. . . ] Note: If the batteries are fully discharged, the time and date must be re-entered. Making a call using the receiver or handsfree feature The telephone can be used like any conventional telephone and, in addition, has some useful special features, which make phoning considerably easier for you. You have two ways of making a call: A: Making a call using the receiver 1. If the number dialled is longer than this, only the last 16 digits will be displayed. If you want to change during a call from the receiver to the handsfree facility, press the button and replace the receiver on the rest. If the number dialled is longer than this, only the last 16 digits will be displayed. If the other party accepts the call, his voice will be heard over the in-built loudspeaker. When using the handsfree facility always speak loudly and clearly towards the telephone. If you want to change from the handsfree facility to the receiver, simply lift the receiver. Calls can be accepted either by using the receiver or by using the handsfree facility. The call duration is shown in the display in minutes and seconds during a call. The call duration still remains showing in the display for a few seconds after the call has been ended. If you want to reset the display during a call, simply press the display will reset immediately to 00:00. If a connection that you have dialled is engaged or you were unable to get through to anybody, simply replace the receiver. The last number dialled with a maximum of 32 digits will be saved in the telephone automatically. You can switch off the microphone during a call using the mute button, . The loudspeaker remains switched on and you can continue to hear the other party. To mute the microphone, press the mute button once while a call is being made. The indicator light will go out and you will be able to continue your call as normal. If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements. You can use the slide switch to loud volume from soft You can use the slide switch underneath the telephone to select the settings HI (loud) or LO (soft) to adapt the ringer volume to your requirements. - The phone book 5 The phone book Using your telephone, you can store 100 telephone numbers with associated names in the phone book. [. . . ] With some private exchanges, there is a short pause between the code for the outside line (usually 0 or 9) and the dialling tone. This pause can be entered when dialling manually and when dialling from the phone book so that the following numbers are not dialled too quickly. Entering the pause when dialling manually once between the code for the outside line and the Press the redial button actual telephone number. After an outside line has been obtained, you telephone will wait for 3 seconds before dialling the actual telephone number. [. . . ]