User manual AUDIOLINE TAM-809

[. . . ] # Switch power on, unit will beep 3 times. 1 SETUP AUDIOLINE TAM809 OUTGOING MESSAGE (OGM) # Ensure the machine is switched on (initial connection red light flashes, green light on). # Repeat procedure if you wish to change OGM message. SETTING THE CLOCK Press and hold the [TIME SET] button until a day is announced. NOTE: If there is a delay of 10 seconds between button presses the procedure will time out. [. . . ] To turn the speaker up, repeatedly press the · volume button. INTERCEPTING MESSAGES # If, while listening to a message being recorded you decide to answer a call, lift the handset on a telephone connected to the same telephone line. # If recording continues, press [STOP] on the TAM809, or # on the telephone you are using. 3 USING THE ANSWERING MACHINE AUDIOLINE TAM809 MEMO RECORDING (NOTE PAD FACILITY) # With the unit switched on, press and hold the [MEMO] button. NOTE: The message light flash rate will increase if a memo has been recorded. VOICE-CONTROL # The unit will record for as long as the caller speaks, up to the maximum time of 60 seconds per message. If a caller stops talking, the unit will disconnect the line after approximately 7 seconds. 2-WAY RECORDING (RECORDING A CONVERSATION) # Press and hold the [TWO WAY] button until a beep is heard (usually 3 seconds. ) # The green light will begin to flash, release the [TWO WAY] button. Warning: If you do not press the [TWO WAY] button to stop the recording, the unit will continue to record, until the recording memory is full. NOTE: The green light flashes rapidly while recording, and a beep will be heard approximately every 15 seconds during any two way recording. IF MEMORY IS FULL # The total recording capacity is up to 11 minutes maximum. # The unit will answer calls after 16 rings and emit one long beep (no new messages will be recorded at this time). The green light will flash, 2 seconds on, 2 seconds off to indicate memory full. # It is still possible to access the unit by remote control, by entering the remote code after the long beep. It is recommended that messages are played and then deleted (manually or by remote) to make space for new messages. POWER FAILURE # During a power failure, the unit cannot receive incoming messages. # Existing messages will be saved (for up to 24 hours maximum) if a good quality Alkaline battery is installed. 4 AUDIOLINE TAM809 USING THE ANSWERING MACHINE REMOTE CODE # A three digit code is located on the bottom of the unit. Please make a note of this and keep it in a safe place. SWITCHING ON REMOTELY If you did not turn your TAM809 on prior to leaving home, you can do so remotely: # Call your home telephone number. # After 16 rings the machine will answer and a tone will be heard # Enter the 3-digit remote code. # One short beep will be heard, enter 9 # and the unit will switch on. If the answering machine does not respond, redial and press each digit for slightly longer. NOTE: The power supply must be connected and the power/unit switched on. REMOTE FUNCTIONS # Call your home telephone number. 1# 2# 3# 4# 5# 6# 7# 8# 9# Play new messages Play all messages Erase current message Skip back one message Stop message playback Skip forward one message Memo recording (5 # to Stop) Record new OGM (5 # to Stop) To turn ON (single beep)/OFF (triple beep) NOTE: If the answering machine does not respond, redial and press each digit for slightly longer. 5 OTHER AUDIOLINE TAM809 FAULT FINDING THE UNIT DOES NOT WORK # Is the power adaptor connected correctly? [. . . ] In the unlikely event of a fault during this period, please contact us for assistance. If the product is then found to be faulty you will be asked to return it directly to us with a copy of the purchase receipt. AUSTRALIA NEW ZEALAND DORO Australia Pty Ltd Atlas Gentech (NZ) Limited PO Box 6760 Private Bag 14927, Panmure Baulkham Hills BC NSW 2153 Australia Auckland Helpline Consumer Support Ph: (02) 8853 8444 Ph: 0900 50-025 (Toll Call) Fax: (02) 8853-8489 Fax: (09) 574-2722 Email: doro@doro. com. au Email: support@atlasgentech. co. nz NOTE: The guarantee does not extend to damage caused by misuse, negligence, excessive voltage, faults on the telephone line or lightning. [. . . ]