User manual AUDIOLINE TAB968

[. . . ] 49 Dialling and storing telephone numbers when using on private exchanges . If you should have any questions, please contact our Service Department on the Hotline number 0180 5 00 13 88. Under no circumstances open the unit yourself and do not try to carry out your own repairs. Intended use This telephone is designed for use connected to an analogue telephone line (PSTN) in Germany. [. . . ] You can now search for more numbers with this letter by turning the Jogdial to the right. The number will be deleted and the display will now show another number from the phone book. Now press and hold the button again for 2 seconds until the message ALLE GELOESCHT appears in the display. Using caller display, you can see in the case of incoming calls who is calling you. If this function is available on your line, the display shows you the caller's telephone number while the telephone is ringing. The display reports the following information when there is no telephone number available. If the message KEINE NUMMER appears in the display, the number has only been partially or incorrectly received. If the message PRIVAT appears in the display, the caller has suppressed the transmission of his telephone number or it was not possible to transmit the number. Your telephone will show the number in the display if your telephone provider offers this service. If this service is not available, incoming calls will not be shown in the display. In your absence, all calls will be saved in a caller list with date and time. When the list is full, the oldest number is always deleted from the list. If calls are registered during your absence, this will be indicated in the display by the message NEU and the indicator light for new calls will flash. Note: The new calls display is not dependent on the calls recorded on the answering machine. Calls will also be stored in the caller list even where no message has been left on the answering machine. Number of all new entires in the caller list You can page through the caller list using the Jogdial. The call is new The caller called several times Name of the caller, if stored in the phone book When all newly recorded numbers have been checked, the new call indicator light goes off and the NEW indicator in the display shows "0". If no button is pressed within 30 seconds, the caller list is no longer displayed and the display shows the current time and date once more along with the number of telephone numbers stored in the caller list and the number of newly stored telephone numbers. Dialling a telephone number directly from the caller list You can dial telephone numbers directly from the caller list. If you want to change to using the receiver, simply lift the receiver. Before dialling, your telephone compares the country and local dialling codes of the number selected with your location (country + local dialling code). If you have entered your country and local dialling code during installation, the appropriate numbers will not be dialled if this is a number from within your country or local network. [. . . ] 1 Telephone Remove all extra telephone equipment and connect only the telephone directly to the telephone socket. If the fault is still present, connect another telephone (if available) to the telephone socket. The results will show you whether the fault lies with the unit or with the telephone line. Of course, you can always ring your network operator's service department, which will give you more advice on checking your installation. [. . . ]