User manual AUDIOLINE BABYCARE V100

[. . . ] Power adapter plug Attention: Only use the power adapter plugs contained in the material supplied since other power adapter plugs could damage the surveillance system. Ensure access to the power adapter plug is not obstructed by furniture or such. When using the equipment with a power adapter plug, pay attention that the plug and cable are in perfect condition. This means that, both in an operating state and in an idling state, the power consumption is considerably lower compared to power adapter plugs with an older design. [. . . ] Putting the Units into Operation Connecting the receiver Attention: Position the receiver with a minimum distance of 1 m to other electronic devices, otherwise there is a risk of mutual disturbance. Operating with a power adapter plug Connect the receiver as illustrated in the diagram. The rechargeable battery pack can be recharged directly in the receiver when it is inserted in the charging station. Using the belt clip/support You can use the belt clip/support as a belt clip by turning it upwards. When tuned downwards, it can be used as a support to keep it in a standing position. Check the transmitter and receiver are working properly each time before the equipment is put into operation. Switching the transmitter on/off Position the transmitter in a good position for the monitoring tasks required and align the camera lens to the area to be monitored. In this event replace the 4 x AAA batteries with fresh alkaline cells. Connecting and aligning the transmitter Attention: Position the transmitter with a minimum distance of 1 m to other electronic devices, otherwise there is a risk of mutual disturbance. Point the upper section of the transmitter towards the baby or object you want to monitor. This enables the transmission of pictures from areas which are not illuminated. The night vision function is activated automatically when the light conditions make it necessary. When the night-time vision function is activated, the screen display on the receiver turns to black and white. Check the transmitter and receiver are working properly each time before the equipment is put into operation. Switching the receiver on/off Press and hold this button until you hear 2 acoustic signals. The logo appears first then the image being taken by the transmitter camera. Use this button to switch the night light on the transmitter on or off. When the vibration alarm is activated, the receiver vibrates when sounds in the room being monitored are so loud that the red Sound Level LEDs are activated. Adjusting the VOX1 sensitivity The VOX1 function (sound detection) causes the system to start transmitting automatically from the transmitter to the receiver immediately a voice or sound is detected. use this button to set VOX to OFF or adjust the sensitivity to one of 5 levels. When one of the five levels has been set, the VOX LED lights up red and the display goes out after 10 seconds. The display is reactivated when a sound is detected or a button on the receiver is pressed. [. . . ] The terms of guarantee do not apply to the batteries or power packs used in the products. All deficiencies related to material or manufacturing errors within the period of guarantee will be redressed free of charge. Rights to claims under the terms of guarantee are annulled following tampering by the purchaser or third parties. Damage caused as the result of improper handling or operation, normal wear and tear, incorrect positioning or storage, improper connection or installation or Acts of God and other external influences are excluded from the terms of guarantee. [. . . ]