User manual AUDIOLINE AB 880

[. . . ] However, due the diverse types of paints and surfaces which come into question, it cannot be fully ruled out that the footpads will leave marks on the surface on which it is located. Only use the AUDIOLINE power adapter plug supplied because other power supplies could destroy the answering machine. There is a risk of fatal injury if the power adapter plug is opened and not disconnected from the power supply. The implementation of European law in national laws and directives obliges you to dispose of consumable goods appropriately. [. . . ] The outgoing message must be at least 3 seconds long and not longer than 60 seconds. the length of the outgoing message is deducted from the maximum recording time. When your outgoing message is 18 seconds, for example, then 49 minutes and 42 seconds remain for incoming messages. You can play back your outgoing message at any time by pressing the REC/x button briefly. The next time a call is received, the answering machine plays the default outgoing message. Setting the number of rings on the rear side of the answering machine is a sliding switch (2 6 TS). Set the sliding switch to the number of times the answering machine should ring before it takes a call. The first call is taken after six rings and all the other calls after two rings. This switch position can be used to implement the toll-saving remote access function. If the caller speaks for a longer period, an acoustic signal is issued and the call is disconnected. If there is a pause in excess of seven seconds during recording, the call is automatically ended, accompanied by an acoustic signal. The answering machine is switched on, the LED above the q/p button lights up. The integrated loudspeaker enables you to listen to messages as they are being recorded. If you do not want to listen-in to incoming calls, reduce the volume by pressing the Volume button z as often as necessary. If you lift the receiver while an incoming message is being recorded, recording is stopped and you can talk to the caller. When the LED above the q/p button is flashing, it means that new messages, memos or call extracts have been recorded in your absence. If the LED is not flashing, all recorded messages that you have not yet deleted will be played back. After the last message has been played back, two acoustic signals are issued. Press the REC/x button until the previous message is played back again. Press the u/CHECK button once to skip the message currently being played. After all messages have been played, press and hold the button until an acoustic signal is issued. The message can be played by pressing the q/p button of the answering machine or via the remote access function using a foreign telefone. [. . . ] The terms of guarantee do not apply where the cause of equipment malfunction is the fault of the telephone network operator or any interposed private branch extension system. All deficiencies resulting from material or production faults which occur during the period of guarantee will be eliminated free of charge. Rights to claims under the terms of guarantee are annulled following intervention by the purchaser or third parties. Damage caused as a result of improper handling or operation, incorrect positioning or storing, improper connection or installation, Acts of God or other external influence are not covered by the terms of guarantee. [. . . ]