User manual AT&T E5908 QUICK START GUIDE

[. . . ] Quick Start Guide 5. 8 GHz Corded/ Cordless Telephone/ Answering System E5908 with Caller ID & Call Waiting Installation & setup After battery installation, place the cordless handset in the charger and allow to charge for at least 16 hours before use. You can keep the battery charged by returning the cordless handset to the charger after each use. When the battery is fully depleted, a recharge takes about 12 hours. The average talk time on a fully charged battery is about five hours depending on environmental conditions, and the standby time is approximately five days. Press in and downward on the tab to open the battery compartment cover. Plug the battery connector into the handset. Plug the large power adapter into an electrical outlet not controlled by a wall switch. Place the battery pack and wires in the compartment. Slide battery compartment cover up until it clicks closed. [. . . ] While phone is idle, press to page base (see page 18) or press and hold to delete all Caller ID entries (see page 33). While a Caller ID entry is displayed, press to delete displayed entry (see page 32). HOLD Press to place a call on hold. Press again to resume your call (see page 16). MENU/CHAN Press to customize the handset's operation (see page 10). During a call, press to switch to another channel if there is interference. REDIAL/PAUSE Before dialing, press to display last number called (see page 14). While dialing or entering numbers into your directory, press to insert a four-second dialing pause (see page 25). NOTE: For more information, please refer to the user's manual. Quick reference guide Telephone Base RINGER VOLUME: Set switch on side of base (Off, Low, High). · CLEAR: While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display. · VCID: Press when phone is idle to display Caller ID information. While entering numbers or letters, press to delete last character entered. · SELECT: Press to store a programming option, or to store a directory entry in memory. While phone is idle, press to page handset, or press and hold to delete all Caller ID entries. · FLASH: During a call, press to receive an incoming call if Call Waiting is activated. · REDIAL/PAUSE: Before dialing any numbers, press to display last number called. [. . . ] · MUTE: Press to silence microphone; press again to resume your conversation. ^V · SPEAKER: Press to turn speakerphone on or off (begin or end a call). Copyright © 2006 Advanced American Telephones. AT&T and the Globe Design are trademarks of AT&T Corp. , licensed to Advanced American Telephones. [. . . ]