User manual AT&T 210

[. . . ] 1 Fill in directory card Remove the directory card and write in your own telephone number. Also write the telephone numbers (or names) that you want to store in each memory location. 2 Connect line cord to telephone Plug the long line cord into the Figure 1 jack on the underside of the telephone base. Then feed the line cord through the channel provided so the telephone sits flat on your table or desk during use (Figure 1). [. . . ] NOTE: If you cannot fit the base onto the wall jack, remove the four non-slip pads. ME ME ME ME ME M2 M6 M7 ME M1 M8 M9 NO . ME M3 M4 M5 THIS ME ME Figure 3 5 Set DIAL mode switch Refer to Step 4 in "Table/Desk Installation. " 6 Connect handset to telephone Connect one end of the coiled handset cord into the base. NO THIS Figure 4 7 Check for dial tone Lift the handset and listen for dial tone. If you cannot hear a dial tone, refer to "In Case of Difficulty" and try to correct the problem. 3 OPERATION Redial This telephone stores in memory the last phone number dialed. However, if the phone is unplugged from the line jack for 30 minutes or more, redial memory will be lost. The number will remain in memory until you change it by dialing another telephone number. NOTE: If the number is more than 31 digits long, no digits will be stored in the redial memory. Erasing Redial For privacy, you can erase the redial memory. Lift the handset, then press 1 and hang up. Flash Press FLASH instead of pressing the switchhook to activate custom calling services such as call waiting or 3-way calling. You may have to press other buttons before or after FLASH as explained in custom calling instructions provided by your local telephone company. 4 Mute While on a call, press PROG/MUTE to mute the microphone. Press PROG/MUTE again to return to two-way conversation. Ringer Volume The RINGER volume switch allows you to turn the telephone ringer OFF, or set it to ring at LO or HI volume. Other telephones in your home will still ring; they are not affected by the switch. Select Ringer Tone You can select from three different ringer tones. 3 Press 3 for Tone 1 ­OR­ Press 6 for Tone 2 ­OR­ Press 9 for Tone 3. 4 Press PROG/MUTE to save your selection. Receiver (Handset) Volume The RECEIVER volume switch on the side of the handset can be adjusted for a comfortable listening level. 5 Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some tone-activated computer systems (e. g. , telephone banking). To change from pulse (rotary) to tone dialing during a call: 1 Dial a telephone number with the DIAL switch set to DP (pulse). 3 After you hang up, the phone automatically returns to rotary service. 6 MEMORY DIALING Memory Features This telephone can store up to 13 different phone numbers, each up to 21 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. Also write the telephone numbers (or names) that you want to store in each memory location. [. . . ] Make sure you choose the correct dialing method (TT or DP); touch tone dialing will not work if you have dial pulse service. If you have tone dialing service, you can use either tone or dial pulse mode. You Can Hear the Other Party, but Other Party Can't Hear You · The Mute feature might be activated. · If you program a number into memory while on a call, the other party will be unable to hear you. 10 Telephone Does Not Ring · Make sure the RINGER volume switch is not set to OFF. [. . . ]