User manual AMERICAN AUDIO TTB-2010

[. . . ] · Turntable Platter · Slip mat · Dust Cover · 45-rpm adapter · Counterweight · Headshell · User instructions VERY IMPORTANT!!After placing the Turntable Platter (2) onto the turntable through the Center Spindle (3), move one of the large windows on the Platter to top right corner. Attach rubber belt* around motor (see fig. 1). (*Rubber belt is already attached to the underside of the Turntable Platter. ) 18 19 20 21 NOTES: · Do not connect the AC power plug before assembly has been completed. [. . . ] (d) Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely). (f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "o" of the ring into alignment with he center line on the tonearm rear shaft. (g) Rotate the counterweight counterclockwise until the scale shows the value corresponding to the pressure of the used stylus. Should you use a separate pick-up system, please follow the manufacturer's instruments. Set the anti-skating control knob to the same value as the stylus pressure. Placement · · · · Do not place the unit in a location where it will be exposed to direct sunlight or near a heating appliance. Do not place the unit in a location where there is high humidity or a lot of dust. Cartridge may pick up slight sound pressure or vibrations of the speakers coming along the floor or though the air resulting in howling. Adjust the legs to stabilize the main body horizontally. Connections 1. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier or receiver or to a household AC outlet. Connect the unit output terminals to the the PHONO jack of your American DJ Mixer or receiver. Output terminals Mixer (Receiver) L (White) (19) ----------------------------> L Channel R (Red) (18) -----------------------------> R Channel GND (Spade) (20) ---------------------> Ground NOTE: Be sure to connect the ground terminals firmly to the Mixer or receiver. If this connection is not made or is loose, a power source "HUM" will result. TTB-2010 User Instructions page 3 User Instructions Operation 1. Push the power button (4) to turn on the power, the speed indicator (8) and the strobe-illuminator will light up. When playing a 45-rpm record with a large center hole, place the 45-rpm adapter (1) on the center spindle. Press the Start/Stop button (5), the turntable platter will start to rotate. [. . . ] Activated the "Fader Start" on the mixing console and the turntable automatically begins Start/Stop. Future American DJ mixers will be equiped with the "Fader Start" function. Maintenance · · · · Clean the stylus periodically with a soft brush to prevent the accumulation of dust. From time to time, the dust cover and turntable cabinet should be wiped down with a soft, dry cloth. [. . . ]