User manual AEG-ELECTROLUX TWSL6S7000

[. . . ] Important safety information Environment Installation Product description Control panel Before first use 51 53 53 56 56 57 Programme chart 58 Daily use 59 Care and cleaning 62 What to do if . In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] ⷠTo keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. ⷠOnce in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance. If the appliance was not transported in an upright position, leave it to stand for 12 hours before connecting it to the electricity supply and using it for the first time, so that the oil can flow back to the compressor. appliance positioning · It is recommended that, for your convenience, the machine is positioned close to your washing machine. The appliance must therefore not be installed on floors which are not resistant to high temperatures. ⷠWhen operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. ⷠShould the appliance be moved, it must be transported vertically. ⷠThe appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The power supply cable must be accessible after installing the machine. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover 1 plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snap-on fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. Unscrew cover plates D from the front of the machine, rotate through 180°, screw on the opposite side. Unscrew door lock E , push down slightly and remove from the front of the machine. Press snap-in button F in and down, press cover down slightly and remove from front of the machine. [. . . ] The condensed water is not suitable for drinking or for preparing foodstuffs. if the programme has been interrupted as a result of the water reservoir being full: Press the START PAUSE button to continue the drying cycle. Cleaning fluff filters The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. [. . . ]